No worries, I just wasn't sure if it was being mistated somehow, since you were under the impression it was a review. I just hope I helped clear that up.
- Status
Be calm everyone. I've stated all the way through the thread that if it wasn't for the HELP of the ECF members that wanted to help I would have never figured it out. It's an opinion that's all. All is good so just vape if you got em. 
I'm not a professional reviewer. I was ask by a person to give an opinion on this device. Nothing more and nothing less. If it was a review I'd have all the youtube set-up to do it the right way.
I'm not a professional reviewer. I was ask by a person to give an opinion on this device. Nothing more and nothing less. If it was a review I'd have all the youtube set-up to do it the right way.
Last edited:
I've ordered one of these and am quite excited to try my first mod 
For those that have this, would it fit an IMR 18650 plus a 2 cent? What about a single 18350 plus a 2 cent? Is the 2 cent necessary or is there protection in this mod that makes it redundant?
For those that have this, would it fit an IMR 18650 plus a 2 cent? What about a single 18350 plus a 2 cent? Is the 2 cent necessary or is there protection in this mod that makes it redundant?
I don't use the 2 cent with mine. I've used a single AW IMR 18650 and also a Single 18350 in mine. Seems to be ok. I finally quit using the VW setting and went with the VV setting. But then YMMV.
If it shorts and blows my face off It might me an improvement.
If it shorts and blows my face off It might me an improvement.
Do you know if a Trustfire 18650 3000 mAh or 18350 1200 mAh fit in ?
Apparently this APV inside diameter is 18,5mm and my Trustfires 18650 are 18,6mm
Apparently this APV inside diameter is 18,5mm and my Trustfires 18650 are 18,6mm
Using the AW protected 18650 and also the Efest and AW IMR 18350. I don't have any trust fire batteries. So don't know. I do know that the AW protected are a really snug fit. Kinda worries me just a bit that they fit that tight but have not had any problems from them. (Yet).
I don't know if any of you guys have heard, but there is a software bug with this device that causes it to over-output when vaping with VW set to 6 Watts. Apparently it is specific to that setting i.e. 5.5W and 6.5W are fine and work as they should. Just avoid setting it it 6W.
Der Vamo
Der Vamo
Last edited:
http://www.e-cigarette-forum.com/forum/healthcabin/351253-ego-apv-6w-bug.htmlThe bug will normally be resolved with next batch.
I haven't set it to 6 watts, so that's ok, but definitely thanks for the heads up.
I have one on order from the co-op and I'm anxious to compare it to my ZMax. I like the ideal of the simple adjustments without the menu system. I leave my ZMax set in the wattage mode so I don't do much changing but when I do I have to get out the directions. It is a great price on the Vamo and I like the fact you can use a single 18350 to make it a little smaller if you want.
There is another warning out on them too about using flat top batteries saying they can short out and cause the spring to melt. I guess the new ones have a gasket so you might check yours if you have one. Here is where it is being discussed. http://www.e-cigarette-forum.com/forum/apv-discussion/351581-safety-issue-vamo-mod.html#post7801120
Saw it. Mine doesn't have the gasket. Guess ill have to make sure I use button tops.
I think ours will be fine. I haven't measured, but I'm guessing that since ours have a much larger center hole where the + terminal connects, it shouldn't be an issue.
Went down there after the doc's visit today. At that time they had 10 more in stock.. All with the gaskets with em. I don't have to worry about flat tops anymore cause I did some trading with Andrew and don't have my vmax anymore. I never really did like it that much. Once I saw the new edition there is a difference. Like I said I never had a problem with my VAMO and flat tops but all the flat tops went with the vmax. Traded for a new Itaste.
went down there... where is there? am looking to purchase one in the US...
ok... okcvapes apparently sent the rest of their vamo's back and is waiting on a new shipment, but haven't a clue on when that is going to be...
do they not have a website?
*edit*... nvm... found them, but they don't answer the phone, and their website doesn't appear to show that they even carry the VAMO... :-/
Last edited:
Their website is definitely a work in progress. As far as I knew, they should be open today. Might try them again later on.
- Status
