Odysseous Dripping Mode O-Ring Question.

[UncleDagger]

Ok. So I've watched Imeo's video a few times now and I still can't seem to find any mention of o ring placement for dripping mode. I've got the small base out of its bag and the drip mouthpiece. Also found the knurled thinner nut to thread around the ceramic holder. What other pieces do I need to install? Does the o ring around the bottom center post need to be changed? What about an O ring that would fit between the base and the mouthpiece?

 

[Zoranth]

The 11x1.0mm o-ring that came with your expansion pack goes between the base and the mouthpiece. No the lower o-ring around the bottom center post does not need to be changed.

Just take your assembled coil, ceramic housing, center pin assembly directly out of the original base. Screw that whole assembly into the dripping mode base and then put the thinner knurled nut on to clamp down the negative wire onto the dripping base.

At least that is how I see it working. I haven't put that part of it together yet as I am working on the illustrations.

 

[UncleDagger]

Thanks. Found that one and installed it. Building a coil now.