Hi
Im very disappointed....
I purchased a P3 Titanium mid july as a bday prez to myself after reading great things about the Provari for the past ten yrs on the forums...cost me nearly 300$ (Im in Europe) and am already having a problem=not working!
I keep getting
=
"Problem = output too high or bad atty [19]
FIX= reduce volts/watts or replace atty"
I use a mini
nautilus with a 1.6 ohm atomizer and vape at 9.6 watts
Tried changing everything : same prob with 4 other mini
nautilus', with Kangertech mini aerotank 1.5ohms .All these work fine on other devices;
Just for the sake of it I reduced wattage to the minimum 3W =still getting that same message........
Im REALLY upset about this . I bought this expensive P3 because i THOUGHT i was buying quality, something that would LAST, that was DEPENDABLE!
My 30-50$ Eleaf Istick 30w & 50w devices are still going STRONG after 8+months of intense usage .I carry my Isticks and Sigelei's around with me all day, theyve been through everything, but my P3 Titanium stays at HOME, only to be used in my living room, didnt even take it on vacation with me this summer (so u can knock three weeks off the 2 months ive had it!) .WHY ? so as to make sure it got no rough treatment, didnt get lost or damaged...ha!
Im jus soooooo

...
The dealer i purchased it from doesnt suggest anything apart from sending it back to him -at my expense- so that he can send it back to the States to Provape for repair.He told me to expect a MINIMUM of six weeks...So thats great! Not even two months with my 300$ Provari and I have to be without for two months ...??,
Anybody have any suggestions I could TRY before having to resort to returning it to the repair-shop ?
id sure appreciate any ideas/input...