Official ProVari 3 Thread - P3

[Bronze]

got it!!!!!

 

[AstroTurf]

Funny thing with the boost set now at 1 after a few puffs no error message. A few more puffs and it was back. So I took the boost feature off and back to what I had with my 2.5. I thought the boost feature sounded great for using an Aspire BVD coil but apparently it's useless. I have to wonder what will work with my 2.8 cartos.

Be Careful...

 

[AstroTurf]

got it!!!!!

Congrats!!!

 

[peakfinder]

got it!!!!!

The end of long weekend and a start of a great week!

 

[NicoHolic]

got it!!!!!

Congratulations! Enjoy!

 

[Pinggolfer]

Be Careful...

I'm wondering if the boost will work on any of my tanks and coils.

 

[Robino1]

got it!!!!!

Congratulations!!! I am hopeful that mine will be here today. Tracking is all messed up.... Keeps changing on me. First says that it is in my area'ish then reverts back to what it said last night. Stupid website...

 

[Bronze]

Congratulations!!! I am hopeful that mine will be here today. Tracking is all messed up.... Keeps changing on me. First says that it is in my area'ish then reverts back to what it said last night. Stupid website...

I intercepted my mail dude just to be sure. He was fixin' on putting it in my mailbox and then discovered it needed a signature so he was reaching for his pad when I got to the truck. I have a good mail carrier and he would of tracked me down had I not shown up at his truck. Can't speak for all of them. The weekend carrier wouldn't even have put it on the truck...guaranteed!

 

[AstroTurf]

I'm wondering if the boost will work on any of my tanks and coils.

I don't think that it will create a problem for any of the Kayfuns or Aspire Naughty Type Tanks...

But, For Cardos, Well that may be another story.

Good Luck, Jim

PS Don't use BooST on Cardos!

 

[Regzzz]

got it!!!!!

Yeayyyy Enjoy!

 

[Regzzz]

Congratulations!!! I am hopeful that mine will be here today. Tracking is all messed up.... Keeps changing on me. First says that it is in my area'ish then reverts back to what it said last night. Stupid website...

x-ing fingers for you!

 

[jimho]

Looking for some suggestions on using my first RDA with my P3. I was at ECC in September and I got a huge selection of juice samples I want to try. I've only been vaping with various tanks, Nautilus minis, Kanger, and my new Silo which I absolutely think is better performing and certainly better looking than the my Nautilus full-size. I picked up a Vulcan RDA some time ago and I want to use that to sample juices on my P3. My other device is a MVP 2 and a Kanger EMOW Mega.

My question is what type of build should I use on the Vulcan with my P3? Will that even work with my P3? I was thinking of two 2 ohm coils for a total of 1 ohm. I'm a complete noobie when it comes to rebuilding. I have to run to San Diego next week and I thought I might swing by a vape shop that I know can build it out for me. Just not sure what kind of build to ask for that will work well on my P3. What gauge wire, etc... The P3 is the highest wattage device I own

Thanks for any and all suggestions.

I'm loving my tugboat - really easy build deck with plenty of room ... I'm building 26ga on 1/8 alan wrenches with 8-12 wraps and there's room for more.....highly recommend them.

 

[NicoHolic]

I'm wondering if the boost will work on any of my tanks and coils.

From what I've seen, if they're 1.8Ω or less, yes, they'll work with BoosT. For a grunge margin, I'd shoot for 1.5-1.6Ω max. OTOH, I also probably wouldn't build lower than 0.8Ω to have a little above the 0.7Ω lower limit.

 

[Zombo]

It's here!! I had it shipped to work. I don't even want to open it....going to wait until I get home so I can properly be with it.

 

[NicoHolic]

It's here!! I had it shipped to work. I don't even want to open it....going to wait until I get home so I can properly be with it.

Congratulations, Zombo. Will they write you up at work for Public Display of Affection?

 

[Regzzz]

It's here!! I had it shipped to work. I don't even want to open it....going to wait until I get home so I can properly be with it.

hehehe. you have WAY more patience than I would!

 

[LX1X]

Congratulations!!! I am hopeful that mine will be here today. Tracking is all messed up.... Keeps changing on me. First says that it is in my area'ish then reverts back to what it said last night. Stupid website...

I feel your pain.. It was 30 miles from my house and it says in transit since 6pm yesterday.

I actually ended staying home... Back pain from yard work this weekend and slight fever.

 

[AstroTurf]

I feel your pain.. It was 30 miles from my house and it says in transit since 6pm yesterday.

I actually ended staying home... Back pain from yard work this weekend and slight fever.

Yea, Yea, Thats what they all say...

We know you got the P3 Virus.

LOLz, Jim

 

[LX1X]

Yea, Yea, Thats what they all say...

We know you got the P3 Virus.

LOLz, Jim

Lol

Well p3 virus is a serious nasty and contagious.

 

[Robino1]

And we HAVE Contact!

Unboxing now in progress