Ohm meters
- Thread starter kaelyn
- Start date
- th_trl_thread_readers 0
- Status
well my current mod from smok is full of errors and i could not enjoy my vaping experience properly hence i am trying to find an replace of mod.. for the errors i keep getting "ohm too high" it's really annoying as i just brought less than 2 weeks
i am running medusa rdta . tsuka coil. the coil resistance is 0.35 but somehow the mod keep reading between 0.5 to 1 ohm randomly
Make sure everything is sitting like it should, check screws, no hotspots, middle pin on 510 is tight and clean under tank and in 510 on mod.
Sent from my Lenovo TAB 2 A10-70F using Tapatalk
Sent from my Lenovo TAB 2 A10-70F using Tapatalk
For a .35 ohm coil I'd say you have an intermittent contact somewhere that's causing that. It could be anywhere from the coil itself to the contacts in the Smok mod.
Contact resistance is likely the problem. The path from the mod's center contact through the mod to the coil is probably intermittent. Try a new atomizer or a different mod to differentiate between possible causes.
Which Smok mod are you using?
Last edited:
Can you take it to a vape shop and have them check it? You are going to need some spare parts to troubleshoot. Swap in a new coil or atomizer and then try the old one in another mod to see if the problem moves with the coil or goes away.
The process of elimination is helpful, but only if you have multiple parts to substitute. Vape shops will help you determine what's going on and sell you a replacement for the bad part if needed.
Last edited:
- Status
Similar threads
