OMG, RBA with a twist.

[bulldog63h]

I have been vaping on an AGA T2 with a 3/4 wrap of 34 gauge kanthal for a few months now. Nice vape. I just twisted two pieces together and put on my I-Atty with a 4/5 wrap and what happened is wonderful. Double the flavor and about 50 or 60% more vapor. That's with a smaller air hole than the AGA. The only question now is will I get the same results with a single strand of thicker wire? I'm thinking of getting some 30 gauge.

 

[SilverZero]

What is the resistance of your new coil?

Twisting the wires together lowers the resistance, so using a thicker wire will have a similar result.

 

[bulldog63h]

On the AGA with the single strand it's 2.7. With the double strand it dropped to 1.9 and that's with an extra wrap.

 

[steeledragon78]

really depends on how low you are shooting for and what you have to drive it. if you are on a regulated device or a vv/vw i would avoid going much lower than 1.5 ohms. if you have a mech, some good batteries and a vapesafe fuse you can go much lower, i stopped at .5 ohms, but my butter zone is .8. granted i use 28 guage untwisted in a 3/4 wrap, fog machine vapor and the flavor is still there.