On stockpiling after FDA deeming regulations

[crxess]

Speaking of which, I have my first ever order of 100mg nic coming. I've never dealt with nicotine in these kinds of strengths and am somewhat concerned.

Can someone tell me how do you handle 100 mg nicotine when transferring into smaller bottles? Do you wear gloves? What about the fumes? Are they harmful?

Has anyone spilled or dripped any 100 mg nicotine on themselves?

As Needed, I break down larger bottles into Groups of smaller(50ml) Jars for actual use.(remaining into 240ml/120ml containers) I purchase only 1 liter sizes.

*Room Temperature before opening
Gloves Recommended
Ventilated(Larger) room recommended - no heavy fumes noted
Nicotine container sitting on counter/table (I use Counter for stability) and open
Nicotine Drawn out by measured syringe(Large 50ml convenient)*
*Nicotine suspended in VG should be warmed first(Container in a Bowl of HOT Water)
Draw Nicotine Solution and place into Working Containers.
Pour Remaining Nicotine into Appropriate sized Storage containers and immediately Seal(Fill to near full to minimize Air Exposure)
Return All containers, Except Working container, to Freezer
Store working container in a Cool Dry DARK area.

Working is basically the same. Warm VG based for ease of extraction. Keep container on a solid Stable surface.
KEEP CAPPED when not in actual use!!!

 

[chanelvaps]

Speaking of which, I have my first ever order of 100mg nic coming. I've never dealt with nicotine in these kinds of strengths and am somewhat concerned.

Can someone tell me how do you handle 100 mg nicotine when transferring into smaller bottles? Do you wear gloves? What about the fumes? Are they harmful?

Has anyone spilled or dripped any 100 mg nicotine on themselves?

Anthony, I do it all the time in my kitchen with no windows open. I have worn gloves and I have just made sure I was close to the sink. If you drip some on you, you will not perish. Of course you would not want to sit around with any on your skin for any length of time. NO ANIMALS nearby for sure because even a small amount on or in them would be a disaster. One of those things where it is important to be careful but also to keep things in perspective. I bought a funnel when I bought my blue bottles and I will transfer, by myself, in my kitchen, no ventilation. Clean up in kitchen sink

 

[Two_Bears]

Anthony, I do it all the time in my kitchen with no windows open. I have worn gloves and I have just made sure I was close to the sink. If you drip some on you, you will not perish. Of course you would not want to sit around with any on your skin for any length of time. NO ANIMALS nearby for sure because even a small amount on or in them would be a disaster. One of those things where it is important to be careful but also to keep things in perspective. I bought a funnel when I bought my blue bottles and I will transfer, by myself, in my kitchen, no ventilation. Clean up in kitchen sink

Right. We are talking about 100 mg/ml not the pure nicotine that is 1000 mg/ml.

When i used nic in my ejuice i made the juice on tge dining table. SK i was 5-10 feet from the faucet.

I put a board on the table and made the juice there. The board had a hole tge size of a 50 ml ejuice bottle so i didn't have to worry about the bottle Falling over if i bumped it with a syringe. Or my arm.

 

[coolerat]

Have only read the first couple of pages and the last few, so apologies if already discussed, but any reason you guys are stockpiling now ? Am i misreading the deemings, or is it that you just don't trust the FDA. Do we not theoretically have access to everything that's currently on the market, until Aug 7, 2018 ? Aren't vendors going to introduce new products at least until Aug 7, 2016 ?

Up until now we Americans have all been in the same boat of waiting for the FDA jackboot to come down.

Now sadly we are broken into 50 smaller groups.

As with all subjects NYers will feel the boot most.

Your in the city so will have access to prolly the largest black market in the world. Things are gonna change on 8/16 for us but you personally may not feel it much.

Upstate we are pretty screwed. Online ordering will be shut down. Juice will still be sold on some level but I'm expecting a tax on it and unless my expectations of Albany fall short of the mark I'm thinking they have something EPIC planned.

 

[Bonskibon]

I'm only six months into this and have had to research and learn so much that I wasn't

Mechs are ok as long you avoid two things.

1. Don't build stupid low

2 don't run a sub Ohm Tank on a mech

I didn't think you could run a non sub ohm tank on one. You saying I could use at tank running a 1.5 coil? I wouldn't build lower than 1 ohm.

 

[Iron Molly]

I'm a MTL tootle puffer, I use 1.5 coils on mechs all the time, and have been for years.

And always test your coils, home made or factory made, before you use it on your device.

 

[Bonskibon]

I'm a MTL tootle puffer, I use 1.5 coils on mechs all the time, and have been for years.

And always test your coils, home made or factory made, before you use it on your device.

Could you recommend one? What should I be looking for?

 

[r055co]

I'm only six months into this and have had to research and learn so much that I wasn't

I didn't think you could run a non sub ohm tank on one. You saying I could use at tank running a 1.5 coil? I wouldn't build lower than 1 ohm.

If it's a series mech it Vapes very well, I like running around a 1.0-1.3 on my series mechs.

And running Tank's on mechs are perfectly safe on a as with all mechs you need to know what you're doing.
Sent from my Nexus 6 using Tapatalk

 

[retired1]

It all depends on what you're looking for. There are some great, inexpensive mechanical mods on the market. I'm partial to hybrids myself, where the tank is part of the mod.

 

[Bonskibon]

Would this be an ok one? Onyx Mechanical Mod Clone - 101 Vape Don't want to spend a lot because only planning on using it if necessary.

 

[coolerat]

Could you recommend one? What should I be looking for?

This is a medium high end authentic mod for 15 bucks. Also in red for 10 bucks.

It uses 18350/1849-50/18650 batteries.

A mod of this class for 15 bucks is insane!!!!

Beyond Vape Beacon Mod - Black Blemished [bv-bea-mod-blk-blm] - $15.00 : Beyond Vape, Premium Vaporizers and E-Cigarettes

 

[r055co]

Would this be an ok one? Onyx Mechanical Mod Clone - 101 Vape Don't want to spend a lot because only planning on using it if necessary.

I avoid Clones with Mech's, Beyond Vape has the Sage mod on sale for $45. I just picked up one, nice well built tube mod

Sent from my Nexus 6 using Tapatalk

 

[Iron Molly]

This is a medium high end authentic mod for 15 bucks. Also in red for 10 bucks.

It uses 18350/1849-50/18650 batteries.

A mod of this class for 15 bucks is insane!!!!

Beyond Vape Beacon Mod - Black Blemished [bv-bea-mod-blk-blm] - $15.00 : Beyond Vape, Premium Vaporizers and E-Cigarettes

That's a nice mod for $15! The only thing it lacks, which I prefer, is that it have room for a Kick. I like the VW and the extra bit of safety.

 

[Bonskibon]

I'm thinking of getting what @coolerat suggested.

 

[Bonskibon]

I'm so confuzzeled.

 

[Bonskibon]

I do own one of these Sigelei ZMAX V3 Telescopic Variable Mod Is this like a mech?

 

[coolerat]

That's a nice mod for $15! The only thing it lacks, which I prefer, is that it have room for a Kick. I like the VW and the extra bit of safety.

It fits a kick with a 18490 or 500 battery.

 

[coolerat]

I do own one of these Sigelei ZMAX V3 Telescopic Variable Mod Is this like a mech?

Well its the same basic shape but otherwise NO!

 

[Iron Molly]

It fits a kick with a 18490 or 500 battery.

Nice! I prefer 18650, but if I wasn't already stocked for mechs, that one is a steal at that price.

 

[Two_Bears]

I'm only six months into this and have had to research and learn so much that I wasn't

I didn't think you could run a non sub ohm tank on one. You saying I could use at tank running a 1.5 coil? I wouldn't build lower than 1 ohm.

I don't see why you couldn't run a 1+ohm coil on a mech.

Where most people get in trouble is trying to PULL 25 amps out of a 20 amp battery