- Status
Good to meet another vaper in OKC! I'm loving my ggts and mr puffer prototype!
Wonder if there's a way if vapers could all meet in 'the city' for a show and tell?
And have you checked out the 'okie vapers' social group yet?
Last edited:
Pretty sure he went the route of the chameleon from ikenvape...or at least that was the direction he was leaning
I HIGHLY recommend the chameleon. It comes with adapters to use with 510s and 801s as well standard, you dont have to pay extra. It also works with PREMIUM cartomizers, and you have the option to go 6 volt if you so choose without buying a brand new device.
It doesn't need a KR8 adapter? The 510(?) threads work fine? Also, it may sound like a stupid question... But is there an led anywhere on it to tell that it is working? I like leds
oh, sorry, ALSO comes with a 901 adapter standard as well. Fits perfectly, and ALL of my cartomizers so far have worked.
Some of the Premium Cartomizers have NOT worked on my BB, so thats important to state.
Lastly, there is NO LED.
Some of the Premium Cartomizers have NOT worked on my BB, so thats important to state.
Lastly, there is NO LED.
I had decide on a Chameleon, had one in my basket and was waiting on him to get batteries in. Then fate stepped in and I got a package in the mail from someone else.
I have a BB now and am happy with it so far. I haven't tried pocket carry yet, but so far it's been very durable, withstanding drops, a two day run time on the 14500's and works every time. As the weather warms I am getting more crazy work, so we will see how it holds up.
I have a BB now and am happy with it so far. I haven't tried pocket carry yet, but so far it's been very durable, withstanding drops, a two day run time on the 14500's and works every time. As the weather warms I am getting more crazy work, so we will see how it holds up.
Saw, can you post your cartomizer compatibility when you have some time? Like I said, some of my premiums did not work on the BB.
Much appreciated buddy.
Much appreciated buddy.
I had a problem with most all of the hard cap premo carto's Born, the soft caps work fine. Leaf is aware of it and has narrowed it down to one manufacture and is working on it.
I've found if you thread it on and off a VK batt about three times it cleans the threads out enough they work most times.
I've found if you thread it on and off a VK batt about three times it cleans the threads out enough they work most times.
What about buying a bit of steel or titanium tubing of sufficient thickness and putting the battery inside so it fits snugly?
The tube should be a bit longer than the battery itself to overlap the cartomizer a bit, just for more protection. You can also grind the carto side to a 45 degree angle just for looks
If the battery is a little too loose in the titanium tube, wrap it in electrical tape and try again.
(Here are a few pictures for reference. Sorry for the rush-job.)
The tube should be a bit longer than the battery itself to overlap the cartomizer a bit, just for more protection. You can also grind the carto side to a 45 degree angle just for looks
If the battery is a little too loose in the titanium tube, wrap it in electrical tape and try again.
(Here are a few pictures for reference. Sorry for the rush-job.)
the prodigy v2 with the new upgraded switch runs at 5v. I am planning to get 1 of those full kit for under $100. If you spend $100 or more FREE PRIORITY SHIPPING. LIFETIME WARRENTY except cross threading. That warrenty in itself is better then any other I have seen anywhere.
I am so close to ordering a V2, but PS says they are still weeks away from shipping their next run. This gives us some time to wait for the VK1...
- Status
Similar threads
