PG/VG ratio for tobacco flavors

[Turbo]

I'm curious what the PG/VG ratio is for tobacco flavors if any. Specifically the 'Lark' and 'Dunhill' flavors.

Maybe they're straight PG? No problems, just curious. I've always wondered and people often talk about their juice ratio and I never know...lol

 

[brandon555]

Its all PG.... unless you order the VG of course...

 

[Absolutely]

All juices, unless specifically labeled as VG are 100% PG.

So, our Dunhill E-Liquid is 100% PG, and our RY4 VG E-Liquid is 100% VG.

 

[Absolutely]

There are certain flavors which you can vary the amount of PG/VG in the mix, but Dunhill and the other tobacco flavors are not one of them.

 

[Turbo]

Ok, thanks, so all the tobacco flavors are 100% PG (unless you order the VG of course). Another thing I noticed is that Dunhill will clog my atties a bit quicker then another tobacco juice of the same color. Guess it comes down to flavoring and not PG vs VG. Good to know.

 

[Absolutely]

The ingredients in the flavoring are usually what cause the clogging. The VG/PG is usually completely vaporized when heated. Usually, the darker the juice, the more it will clog. You might try cleaning your atomizers in PGA (pure grain alcohol) or put some pure PG in them and blow them out to remove some of the clogging issues. Other people suggest boiling or soaking in distilled water to be a good solution, too.

If you use PGA or water, be sure to let it dry completely before using again. PGA can cause the atomizer to heat too quickly and damage or break the heating coil inside. Water will do the opposite and cause little or no vapor to be produced.

Of course, the best solution would be to just pop a fresh atomizer on there when it starts to not perform as well.