Phase 1 of conversion complete!

Status
Not open for further replies.

unloaded

Ultra Member
ECF Veteran
Verified Member
Jun 2, 2011
2,491
2,365
SW. Indiana
Well the EfferDent seems to have done the trick. Took it all apart and soaked it in hot water with two tablets. After 15 minutes I rinsed it all off and put it back together. I didn't try saving the bottle or tube, might try that later. Put a different bottle and tube on it and filled her up with unflavored. vaping great and no signs of cinnamon. Gonna need a rebuild kit, the center pin is sitting pretty low. It's also wore enough that the slot in it is practically gone. Not enough to get a bite with a screwdriver so I could unscrew the bottom half. If I put a thin oring under the atty it doesn't make contact. Luckily one of my attys has the coil oriented right when tightened down. The red is starting to grow on me. Might need a big IU decal on it!
 
Status
Not open for further replies.

Users who are viewing this thread