PhenomenoN our New RBA only from GUS
- Thread starter aiolos
- Start date
- th_trl_thread_readers 0
- Status
Not a wol, but did you see the "essential" model....I think anavid has one and could post an in hand pic. Perhaps he could matte finish it for you too.
Essential 14500 GUS Battery case BTO series [Q40-J6X00] - €90.00 : Gus-mod&more...!, An idea made material
That is the Eight Roads Setup correct? I saw that too but it's 14650. If it was 14500 i wold have bought it already.
Still want an anavifan dark one day.
Perhaps a Ss tube with the Gus thumb print all over it, sporadic so it can become a design and hard to understand what it is unless you know, and the bottom button lord finish instead of the thumb print.
Perhaps a Ss tube with the Gus thumb print all over it, sporadic so it can become a design and hard to understand what it is unless you know, and the bottom button lord finish instead of the thumb print.
What are you doing...trying to bring about the end of days? Dear God man!!!
^^ The one in my pic is 14500. The 14650 one is tad different (I'll post a pic later).
I was bored ok.
I loiter in this section all day long hoping Aiolos and/or any of you post a picture of something.
What can I improve on for my next phenomenon build to stop it from "spitting" at me on the first puff after its been sitting for a few min? I know it happens from a little juice getting on the outside of the coil, but what can I personally improve on/fix in my next build? *Obviously it's not the fault of the Phenomenon - just looking for some build refining advice folks.
Loving the heck outta the Phenomenon so far!
-Sent via Tapatalk
Loving the heck outta the Phenomenon so far!
-Sent via Tapatalk
Last edited:
Ive often wondered why some builds "spit" Ive heard its the spacing, or slightly too much liquid, but Ive never found the rhyme or reason. I dont get it often on the Phenom, but do get it on some drippers occasionally and on my "other tank atty", dont want to mention it or might be accused of being a "fetishist". 
Maybe I'll try "more power"! Haha. I was at 13.2 watts. We'll see what 14 with the P3 boost 2 does to it. I already tried backing it down to 12 watts (still with boost 2) and it still spit at me.Ive often wondered why some builds "spit" Ive heard its the spacing, or slightly too much liquid, but Ive never found the rhyme or reason. I dont get it often on the Phenom, but do get it on some drippers occasionally and on my "other tank atty", dont want to mention it or might be accused of being a "fetishist".
Edit - just did it. 14 watts and it's even tastier! Started mixing a little (25%) Wakonda with 75% The Virus (both obviously from Nicoticket).
-Sent via Tapatalk
what gauge wire are you using? Ive also heard that thick wire that takes longer to heat combined with high power will cause that sudden pop !
Ive also heard that happens with you make a lower resistance and your battery is running a bit low and since its heating up slower it will pop and spit when it finally heats up.
Ive also heard that happens with you make a lower resistance and your battery is running a bit low and since its heating up slower it will pop and spit when it finally heats up.
- Status
Similar threads
- Locked
- Locked
