Pictures of your setup

Status
Not open for further replies.

vaptamist

Vaping Master
ECF Veteran
Verified Member
Oct 14, 2011
3,447
6,530
FL
y9LKy.jpg
 

snork

Vaping Master
ECF Veteran
Verified Member
May 30, 2011
6,181
11,235
CO

trpxcst

Senior Member
ECF Veteran
May 20, 2012
94
54
South Dakota
Nothing too impressive here to show - been vaping less than 2 weeks, but I have parts on the way for building a couple of mods...

My "sitting down for reading ECF" setup.

2 1100mAh KGO batts
a couple of attys
some filled cartos
a couple of drip tips
and a bunch of different juices
(I bounce around a lot when I am reading)

IMG_20120623_180637.jpg
 

Rhals

Full Member
Jun 9, 2012
69
42
Denver (5,675 ft)
Looks nice but what does the thumb screw do exactly?

The thumbscrew goes in the fill hole, which I made using a 7/64 Dremel drill bit, and it allows me to add juice through it without removing the tank's cap. I found taking the cap off the tank is a bit tedious because of the tight fit, and also when I put the cap back on the pressure is enough to flood it so I need to disconnect the tank for refills too. With the thumbscrew, taking out the screw is the only disassembly needed so it's a quick and easy refill.
 
Status
Not open for further replies.

Users who are viewing this thread