I don't know if it's been discussed within the beta group, but the 18650 version is already positively tiny!
Printed Mechanical Bottom Feeder Mod
- Thread starter gdeal
- Start date
- th_trl_thread_readers 0
- Status
I don't know if it's been discussed within the beta group, but the 18650 version is already positively tiny!
Yes I love my 18650 Peko. As you can tell, cause I've got 3! I have a mini Reo and the 18650 Peko is almost same in size. Actually the rounded edges make the width smaller than the Reo. I use to love Reo.. but I sold them all buy my mini Lp to get more Peko! The 18650 Peko is already small, and you get awesome battery life to boot!
-Mark
3d parts were due to ship today. Shapeways says could be as late as the 17th.
I found the gdeal youtube channel. Watched some gdna vids and a 1mm squonk one. Is squonking slower to feed than a reo? It looks it
Sent from my GT-I9506 using Tapatalk
I found the gdeal youtube channel. Watched some gdna vids and a 1mm squonk one. Is squonking slower to feed than a reo? It looks it
Sent from my GT-I9506 using Tapatalk
did you get the strong white flexible or colored parts?
about the slower squonk - for me, that seems to be dependent upon the size of hole in the atty. when i squonk without an atty on the reo and the peko, i really don't see a difference.
just the strong white and flexible. haven't decided about a finish yet, maybe ink with a clear coat
looking forward to seeing the finished product. i don't think anyone has posted an inked peko yet. you mean like alcohol inks?
George needs more coffee.
For flow, what matters is the area of the hole (which goes up with the square of the diameter) and the ratio of that area to the tube's inner surface (which is where friction occurs, and that inner surface area only increases linearly with diameter). Thus for the purpose at hand, 1/16" should be regarded as at least 2.5x "larger" than 1mm.
Last edited:
You're really bad at being the Greeks spokesman aren't you?
Well...it's kind of kataphraktos signature: "Rossum could show his wood to the waitresses."
No, Hey, Don't let me stop ya, Ask away
Seriously...I'm more interested in 18490 PEKOs.
I would suppose next you'll want it regulated also???? Not enough life in an 18490 to warrant going either route...
I've never understood what anyone sees in the 18490 form factor. Not enough battery time or juice capacity for me. I'd be constantly changing batteries and refilling.
Well, in this instance the difference in capacity is between a 6ml bottle and perhaps a 4ml and is not that great. For the Sun Box I have two of the new 18490 AW's in a box and 1 in the device most always. I carry a laptop bag with a touchpad and building stuff, juice, to the office everyday. There are two 18650 PEKOs and a BilletB in the side pockets. I can swap around as I like change batteries or juice as I like.
Truly, I just think it would be pretty frikkin cool to have a PEKO that would fit nicely in my vest pocket, a 14mm atty...a I ohm dual build..like that.
Truly, I just think it would be pretty frikkin cool to have a PEKO that would fit nicely in my vest pocket, a 14mm atty...a I ohm dual build..like that.
Last edited:
- Status
Similar threads
- Locked
