Prodigy V3.1 Cartomizer issue?

Status
Not open for further replies.

BuddyGoodness

Senior Member
ECF Veteran
Verified Member
Nov 22, 2010
207
24
Mississippi
For the past few days I have not been able to get any cartomizers to function on my prodigy. Atomizers still work fine but not cartomizers. It is a weird problem. I tried contacting puresmoker but I haven't had a response. Is there something I can do to the top cap? Maybe the connector needs pushed up further into the 510 threads?
 

Stevowns

Full Member
Sep 16, 2011
49
12
US
I've been told that the top contact post an be pushed down if you over tighten. I haven't done it yet myself, but was told that you just need I use some solid like the back of a small screwdriver to push it back up. Shouldn't move much, just a tiny bit. Hope that helps.

Wow, I've been having this issue for a couple weeks now, thanks for your input! All I did was use the back end of a plastic pen (one of those cheap ones) and pushed it until I heard it click back up. I thought i had a bad connector too, where It wasn't firing properly, but now its all good to go again :)
 
Status
Not open for further replies.

Users who are viewing this thread