protege sleeve

[funkybozu]

is it possible to get a sleeve for the protege so you can fit 2 14500s??

now that there are HVatties out there that can handle the load
if i could get a sleeve for the protege that would be my n#1 vape

 

[cappy]

2 14250 3.7v 300mah will do it.

 

[BrockJ]

I bet it'd cook the switch almost instantly.
May be able to pull it off with the mechanical switch they're releasing.

Sounds skeeeeeeery ...



.

 

[j4g3rb0mb3d]

It wouldn't cook the switch. They are the same switches in the USBpass and the Prodigy V1

 

[BrockJ]

There have been an unusually high fail rate on the protege switches unlike the "same" switch that's in the Prodigy.
The Protege's seem a lot less tolerant of shorting, arcing, etc... may have something to do with the Satinless....
I have both (well actually two of each) and the Prodigy switches have never been an issue. I've put at least 5 switches in the Protege's (ordered extra tact switches).

And, we're not talking about 5 volts were saying hitting it at 8.4 - 7.4

That would be my only concern. Switches aren't that hard to replace if you happen to have some.

.

 

[funkybozu]

the mechanical switch should right that wrong
im already vaping at 8.4, and it just great

 

[jorge1845]

where can i get some HV attys, u can PM me if you dont want to say it here, thanks.

 

[lotus14]

where can i get some HV attys, u can PM me if you dont want to say it here, thanks.

Same here, if you don't mind.

 

[funkybozu]

humm.... not a secret but im not sure i should post it in PSs forum?

 

[umjim]

Why not? They don't sell them.

 

[Lightgeoduck]

Why not? They don't sell them.

because it may not be kosher to post one suppliers site in another's payed for sub-forum.....

I don;t think it is a big deal,,, but really it's up to the PS crew don't you think... I mean only out of respect

of course this is my opinion

 

[Col. Gaunt]

2 14250 3.7v 300mah will do it.

Yeah sure they will cappy, sure they will!