Provari 3 Kayfun leaking issues

[FundamentalForce]

This isn't a huge deal as it's only a few drops, but my kayfun lite plus 2 is leaking (I believe around the bottom air hole) onto my Provari 3. This is the only mod I have it leaks on, leading me to believe it's the 510 connection of the ProVari. Does anyone have any advice? thanks!

 

[keonee]

Provari 3....where did you get one? Doesn't the the new P3 have a Self-adjusting center contact pin. This is a feature that Provape's been advertising...The new P3 thread is a unique top connection which allows you to adapt multiple tanks including 510.

Good Luck to You!!!

 

[FundamentalForce]

I was lucky enough to get one of the few retail Betas. Yes it does have an adjustable pin, and its own 510. Most tanks fit perfectly flush, but there still is a little space with the Kayfun.

 

[Spooky Mulder]

Send the P3 to me. I'll fix it.

 

[Nomoreash]

Leaking of an atty isn't caused by the P3 or any other pv for that matter, all the pv does is provide power through the threaded connector.

With the Kayfun it's usually seal, vacuum, or wicking related. If it's just a few drops and everything is fit and sealed properly it's probably just pulling a we bit to much juice into the chamber. You can try loosing the airflow adjustment just a little if it's not already wide open and that should help.

 

[FundamentalForce]

Thanks guys!

 

[EuroChris]

Kayfuns shouldn't leak through the center pin. You need to check the insulator of the center pin. Could also be that the center pin isn't tightened properly.