Rba help

[Maverick09125]

Im fairly new to vaping. I started off with and ego and upgraded to spinner vv and now i have a tesla mod. Im looking into getting an rba. But dont know much about it. Any help would be appreciated. Thnks

 

[porkchopbun]

I would just start out with something simple like Kayfun, so your best bet is to youtube some videos on Kayfun builds and then do forum search on Kayfun itself. There are tons of threads in this forum on Kayfuns, etc.

Later on you can get into drippers, Gennys, etc.

 

[Maverick09125]

Will that work with the electronic tesla mod?

 

[dice57]

Kayfun, Russian, flash-e-vapor V2, Taifun GT, all would be and excellent choice. Can run any rba on a telsa as long as the ohms of you build are within the appropriate range. Good luck, have fun!

Vape long and Prosper!!!

P.S.: The cat bites!

 

[Kovertkow]

Yes but you should look into picking up a ohm meter. A legit kayfun will cost you 90$. I own three and they are well worth it. a kayfun clone will cost you 30-40. I snagged a clone for a buddie and it isn't that bad of a rba. A genesis style atomizer can be finicky to get going right but they are worth it. Also a squape or a taifun might be worth looking into.

 

[Baditude]

Will that work with the electronic tesla mod?

A Kayfun style rebuildable tank atomizer would work great on a regulated mod like the Tesla. The Kayfun is a flavor machine and a relatively easy setup for a beginner.

You won't be able to do sub-ohm coils on a regulated mod, but that's ok with a Kayfun, which works best with ohms in the 1.3 - 2.0 ohm range anyway. A genuine Kayfun can be hard to find and be expensive ($90+), but there are clones available for 1/3 that.

Information Resources for Your First RBA

 

[Kovertkow]

Be careful of the kayfun clone you get, my buddie just snagged a clone from a BM so no idea as to its origin... And it's a flop... Can't seem to get it working right and it leaks at the tank connections.

 

[brickfollett]

Genesis are finicky at first and require a learning curve+practice. When you finally get it right and figure out the build that works to your liking, they have potential to blow Kayfun's out of the water.

That's been my experience, and I'm sure it's not been the experience of a fair chunk of the others, but they are capable of impressive flavor and vapor combined into a nice package. The Pyrex RSST has been my favorite thus far, inexpensive and easy to build on for a beginner. Pyrex RSST quality is much greater than that of the original RSST too

 

[Venge ODay]

I just finished MY first rebuild about 30 minutes ago. My advice is watch the Youtube videos as previously suggested and read the forums here first like I did. This place has a wonderful store of knowledge.

These guys and the vids prepared me, I never had a lick of trouble. Good luck!