RDA for REO Grand (regular profile)

[ecitek]

I see people using modded RDAs on the Lo-profile REO Grands, but not sure if I have seen one that will work for the regular ones.

Any suggestions?

 

[jkais3r]

I see people using modded RDAs on the Lo-profile REO Grands, but not sure if I have seen one that will work for the regular ones.

Any suggestions?

I think most that will fit the standard grand are mostly bottom-fed, or available in bottom-fed versions. ERA, Hornet, RM2, IGO-S, Chalice, Cyclone, etc.

Or are you looking for a cheap rda to convert to bottom-fed? If that's the case someone'll have to post the specs I think it's 17mm or smaller or around those parts. Don't buy something off of me saying 17mm though because I'm not positive.

 

[Hdivr]

The Reomizer 2 is milled to fit the regular Grand. I've been using an A7 with much success. It fits perfectly and the draw is just like a cartomizer (which I prefer to side holes). No leaking and can still hear the "squonk". If you go the A7 route, I would suggest taking a hole punch to a carto condom and making a gasket to secure the center pin in the rda. The hole punch makes the perfect size gasket and the center post won't wobble which could cause a short and spring collapse.

 

[ecitek]

Or are you looking for a cheap rda to convert to bottom-fed?....

Yes. I want to play with an RDA conversion to bottom-feed, but has to be small enough to fit in the top of the REO.

 

[Filthy-Beast]

This thread is full of RDAs that people have modded for the Reo, needs to 15mm or smaller in diameter.

http://www.e-cigarette-forum.com/forum/reos-mods/377836-reo-compatible-rbas.html

 

[Hdivr]

Or you can turn your Grand into a LP in 5 minutes on a bench grinder.............

 

[Dconnor]

I just did a YK1 from Fasttech. Below on an LP but will fit a regular Grand.

 

[patrao_n]

Also the a6 from fasttech is easily made bottom feed. Just cut a slot down the center post. The igo-s as well.

Sent from my SM-N900T

 

[mackman]

Desert Vapes sell an A6S Bf (Rebuildable Drippable Atomizers) all you have to do is drill an cap air hole. All in all a nice unit

 

[Dconnor]

I like the mini A7 as well. A little tight to build on though. Comes as bottom fed air. Have to cut off center tube and drill side air hole. Nice flavor and drains well once done.

 

[Rat2chat2]

I am so happy with the rm2 that I haven't wanted to find anything else, but I think it is fantastic. Happy sqwonking.