Interesting. Thanks for that. I see they make one with the SX350 chip as well. Seem to be sold out at the moment, though.You may want to check out the M-vapes from UK. They make dual 18650 squonkers. All the reviews I have seen were very positive.
Interesting. Thanks for that. I see they make one with the SX350 chip as well. Seem to be sold out at the moment, though.You may want to check out the M-vapes from UK. They make dual 18650 squonkers. All the reviews I have seen were very positive.
Hey my fellow rda junkies!!!! After reading some of your thoughts I have decided to look into squonking and BF rdas. I was looking for dual 18650 squonk mods and could not find any!? Is this not a thing? Also what would be a good (hopefully affordable) squonk box to start with? Thanks for your input !!
Many of the dual 18650 squonkers are huge! I think they should take the form of an RX200 (squonk bottle in front) or just use 26650s to cut down on the size.
Edit . . . man, that dude @inswva linked to has some awesome wares!
Those are kinda nice and not all that expensive relatively speaking.Interesting. Thanks for that. I see they make one with the SX350 chip as well. Seem to be sold out at the moment, though.
Yes... yes, he does. I have one and am on the list for two more. They are absolute works of art.
![]()
And, I haven't forgotten about you, brother. Stuff has just been crazy busy this week.
Stoooooop! My god that's sexy....must resist.
Questions for you all, if you're building on a mechanical device with a 26650, how do your builds differ from mechs with an 18650?
I know this one has probably been discussed to death, but I got an Origen Little BF delivered today. It's on a Reo Grand with a single center (Z) coil made from 28ga Kanthal, 2.0mm diameter, .8-ohms to heat quickly - and preserve battery life.
Gotta say this thing is fantastic. Lots of vapor and flavor. Probably going to relegate my Nuppin' to back-up status, or I may even sell the Nuppin' to fund another Origen for back-up. It's really that good.
And even though it's small, it works on the Grand.
Crappy cellphone pic:
View attachment 540257
Questions for you all, if you're building on a mechanical device with a 26650, how do your builds differ from mechs with an 18650?
I might just have to get one of those...
How would you compare the airflow to a Nuppin? Looks wide open - is that comparable to a Nuppin wide open, or a little more restricted?
OK, dug out the Nuppin' from my spare atty box and took a pull on it and immediately followed with the Origen. With the Nuppin' wide open and the Origen wide open they are VERY close. Maybe a very very very small edge to the Nuppin', but close enough to call it subjective.
I do rda's exclusively, in fact just one, the SV. It does favor and MTL better than any of the small collection of other drippers I have. Since the air supply is only one one side it's less complicated to control leaking for pocket carry. I'm so partial to the SV I don't want to buy another rda unless I'm pretty sure I'll like it at least as much. So I saw the Penny recently. Does anyone have one? The SV is so good at flavor I can get by with 1%. At that low percent my other rda's become almost flavorless.Unfortunately there's no hole, I wrap the wire around the post & tighten down. Just built mine tonight with a SS vertical coil. Yep, it's still worth the money.
View attachment 540146
This is a beautiful mod!