RDA RDA's for DIY BF

[K31Scout]

Which rda's have center pins that will tap out? I've done a few Atomics with a dremel cutting wheel that turned out great. I've been looking at cloned Rogue and Odin which look like they'd tap or press out. I'm interested in the Manta also but that looks like a drill press job.

 

[sofarsogood]

Which rda's have center pins that will tap out? I've done a few Atomics with a dremel cutting wheel that turned out great. I've been looking at cloned Rogue and Odin which look like they'd tap or press out. I'm interested in the Manta also but that looks like a drill press job.

In general all these products had to be assembled so they can be disassembled. I use an SV rda clone. It appears the center pin is held in place by a lower nut. An upper nut plus the lower is used to trap a lead.

 

[K31Scout]

Well I took a chance and ordered all 3 from fastec to see what I can do. If nothing else I can drip to see if I even like them.