Reo Lovers DIY Recipes

Status
Not open for further replies.

stravaigin

Vaping Master
ECF Veteran
Verified Member
Dec 15, 2010
5,531
8,892
Australia
Bavarian Cream & Hazelnut! Make it at 20% flavor. Your choice of nic, VG/PG. You might want more of the Hazelnut than the Cream if you want it less sweet! If you want a little more kick in it add some Jamaican Rum!

:) thanks Karen I wasn't sure what percentage flavour to use. Is that 20% of each flavour or 10% of each? sorry for being thick about this.
 

nerak

ECF Guru
ECF Veteran
Verified Member
Feb 12, 2011
25,335
60,415
Fairfield Township, OH, USA
www.facebook.com
:) thanks Karen I wasn't sure what percentage flavour to use. Is that 20% of each flavour or 10% of each? sorry for being thick about this.

Hey, we all had to learn! Not a problem! 20% is the total. So divide that amount equal or more if you want one flavor a little stronger.
 

nerak

ECF Guru
ECF Veteran
Verified Member
Feb 12, 2011
25,335
60,415
Fairfield Township, OH, USA
www.facebook.com
What size would you suggest I get? I saw some on ebay after you mentioned them but again wasn't sure. At this rate I'll have to ask Gil to swap names!

Those glass tubes are very long. The 5ml is 12inches, and the 10ml is 14. I got both. I am satisfied with those mls.
Did you check Amazon? Don't know if they ship to you, but they have everything there too.
 

stravaigin

Vaping Master
ECF Veteran
Verified Member
Dec 15, 2010
5,531
8,892
Australia
Those glass tubes are very long. The 5ml is 12inches, and the 10ml is 14. I got both. I am satisfied with those mls.
Did you check Amazon? Don't know if they ship to you, but they have everything there too.

Thanks again. I don't know about Amazon, I'll have to check. I do have an account as I just bought a kindle but haven't got out of the Library to explore yet!
 

Erfmann

Ultra Member
ECF Veteran
Verified Member
Feb 27, 2011
2,023
2,680
Arizona
Alisanne, we bought the pipettes and the pumps from here, since we were ordering a few flavors anyway....we seem to use the 2ml and 5ml the most....2ml is nice for little test mixes, altho we could make do without it, since most small test batches we could just count drops...
They are pretty slick tho, I would for sure recommend the larger 5-10 ml pump and pipettes, and both pumps and pipette sizes if you can...

Not sure how the prices compare to amazon...I didn't look...like I said, we were ordering flavors at the time, so we just added them...

One Stop DIY Shop
 
Last edited:

stravaigin

Vaping Master
ECF Veteran
Verified Member
Dec 15, 2010
5,531
8,892
Australia
Alisanne, we bought the pipettes and the pumps from here, since we were ordering a few flavors anyway....we seem to use the 2ml and 5ml the most....2ml is nice for little test mixes, altho we could make do without it, since most small test batches we could just count drops...
They are pretty slick tho, I would for sure recommend the larger 5-10 ml pump and pipettes, and both pumps and pipette sizes if you can...

Not sure how the prices compare to amazon...I didn't look...like I said, we were ordering flavors at the time, so we just added them...

One Stop DIY Shop

I missed this earlier, sorry for not replying Earl. I'll definitely try and get the 5 and 10ml. I think I'll be able to get them from ebay Australia as the DIY shop doesn't ship internationally, I wish they did as they have a great selection. Say hi to Rita for me and thank you for the info :)
 

Della Cirque

Vaping Master
ECF Veteran
Verified Member
Oct 1, 2011
7,746
30,961
52
Deep East Texas
Not into DIY yet...but I've been stalking the Reo threads for awhile and went ahead and peeked into this one. SO glad I did! I was under the impression that I needed distilled water to thin my too thick juices. (and I haven't pulled myself away long enough to go to the store!) Saw to use bourbon, which I have. So a couple of drops of SoCo and Gourmet Vapors Peanut Butter Cup and the juice is thin enough to use and tastes delicious!

Anxiously waiting to become a Reonaut~Jen
 

davelog

Vaping Master
ECF Veteran
Verified Member
May 4, 2011
6,134
20,989
Phoenix
www.davelog.com
Here's a 10ml recipe for one of my favorite all-day vapes. I call it Cartoba!

Royal Tobacco (Flavourart): 6 drops
Desert Ship Tobacco (Flavourart): 6 drops
MTS Vape Wizard (Flavourart): 4 drops
Bavarian Creme (LorAnn): 4 drops
Caramel (LorAnn): 16 drops
Distilled Water: 4 drops

Top off to the shoulder with your base - I use a 50/50 24mg. Steep in hot water bath for an hour, shaking every 15 minutes, then let it sit in a cool dark place for a week or more. YUMMY.
 

FeistyAlice

ECF Guru
ECF Veteran
Verified Member
Aug 24, 2010
11,566
26,426
Near Dallas Texas
Here's a 10ml recipe for one of my favorite all-day vapes. I call it Cartoba!

Royal Tobacco (Flavourart): 6 drops
Desert Ship Tobacco (Flavourart): 6 drops
MTS Vape Wizard (Flavourart): 4 drops
Bavarian Creme (LorAnn): 4 drops
Caramel (LorAnn): 16 drops
Distilled Water: 4 drops

Top off to the shoulder with your base - I use a 50/50 24mg. Steep in hot water bath for an hour, shaking every 15 minutes, then let it sit in a cool dark place for a week or more. YUMMY.


YUMMMMMMMMM! This looks like one I might like; no chocolate, coffee, or fruit. This goes to my recipe text keeper right now.

Thanks!!!!!!!! Alice
 

FeistyAlice

ECF Guru
ECF Veteran
Verified Member
Aug 24, 2010
11,566
26,426
Near Dallas Texas
Thanks, there are 2 DIY recipes that comprise about 90% of my daily vape, that was one of 'em. The hot steep+wait make a huge difference, it tastes pretty raw when you first mix it but mellows considerably over time.

The "hot steep" is a brilliant idea. Does it help other mixes, too. I'm going to do your recipe for DH and then do one with less tobacco for me. Most of my all day vapes are very heavy on the butterscotch except for FSUSA Applewood. Sure would love to find a recipe for that.

Hugs, Alice
 

davelog

Vaping Master
ECF Veteran
Verified Member
May 4, 2011
6,134
20,989
Phoenix
www.davelog.com
Absolutely. I do my hot steep with an ashtray (sweet delicious irony) which is tall enough to hold the bottles upright, but low enough to where the water can run out the ....-holes (hee!) around the sides to maintain a water level within. I set this directly under a hot tap that's just running at a dribble, and voila! Hot water bath for DIY bottles. Sure, the water only goes about a third of the way up the bottle, but that's what the 15-minute shakes are for, to distribute heat and mix.
 
Status
Not open for further replies.

Users who are viewing this thread