Reo P 67 prototype

Status
Not open for further replies.

KentA

Ultra Member
ECF Veteran
Verified Member
May 5, 2015
1,251
3,153
76
Adirondack Mountains
U-oh!!! I just checked the site and I don't see the black wrinkle, purple SL door.... Am I missing it? Yesterday, there were 2. One on each pg. Perhaps it's just put away for me?
I picked one of those up in the "pre-sale".
 

Train2

ECF Guru
ECF Veteran
Verified Member
May 11, 2013
12,273
36,193
CA, USA
What, this one?
Yeah, moved it to my cart.
Reo_P_67__black__56c4d6c435acb.jpg


((JUST KIDDING))
 

Debadoo

ECF Guru
ECF Veteran
Verified Member
May 18, 2012
18,052
133,969
Texas, near Fort Hood
If I spring for the P67 do I use the Low Profile - RM2 Atty with this mod?
you CAN use either one. But the SP rm2 will have the brass showing that normally you wouldn't see because it's in the catch cup. the lp rm2 will be all nickel showing

U-oh!!! I just checked the site and I don't see the black wrinkle, purple SL door.... Am I missing it? Yesterday, there were 2. One on each pg. Perhaps it's just put away for me?
I'm sure it's put away for you....he wouldn't dare go around hidin purple!!


I picked one of those up in the "pre-sale".

^^^^^ :lol: :lol:
Yeah, I picked up a few of these in the "pre-sale" as well.

What, this one?
Yeah, moved it to my cart.
Reo_P_67__black__56c4d6c435acb.jpg


((JUST KIDDING))

hope I got the timing right on this

ETA wanted it to start with the pie, so got it almost right. wish we could take just a piece out of vid, start and STOP where we wanted to. that would be kewl sometimes
 

Debadoo

ECF Guru
ECF Veteran
Verified Member
May 18, 2012
18,052
133,969
Texas, near Fort Hood
I'm hoping there will be one left when I get off work Friday night. Unfortunately, I don't think that'll be the case. :(
I expect there will be.......there are not nearly the folks goin wild about these as did the woodvils I don't think. He'll have around 200ish of these I think, so I would think you'd be ok. Now I shouldn't post this, cuz me sayin that will just about guarantee there won't be! :facepalm: Seriously though I would think you'd be fine. But if there is someone you know well and trust on here that could get it for ya, I expect they would. You'd just need someone you really trusted with your CC number

:D :lol:
 
  • Like
Reactions: Robinowitz

Papa_Lazarou

MKUltra Member
ECF Veteran
Verified Member
Aug 23, 2013
5,867
21,663
Gabriola Island, Canada
I'm thinking of going with a hammer tone. Is the texture similar to black wrinkle?

Hammertone is smoother to the touch than black wrinkle, but still textured. It reminds me of those old film projectors we used in school when I was a kid. Some tool boxes use it as well.

As you can gather from those other applications, it's a very durable finish - the most, in fact, of any of Rob's finishes.

I have an SL grand hammertone that is my often daily work carry and that thing has seen it's fair share of drops and bumps. Not a single blemish. It did, however, mar the toe of one of my shoes from a drop.
 
Status
Not open for further replies.

Users who are viewing this thread