Can I drill out the center post? The holes are wayyyy too small for any build I like to vape on. Anything I should keep in mind while doing this?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Rm3 questions. Help!
- Thread starter jimkipila
- Start date
- th_trl_thread_readers 0
- Status
I'm sure someone will come along and have an intelligent answer for you but I remembered this post and it had a great picture so I was hoping that it would help. http://www.e-cigarette-forum.com/forum/reos-mods/581916-rm2-not-draining-very-well.html
If this doesn't help you...........hope you have a great afternoon.
If this doesn't help you...........hope you have a great afternoon.
If you are talking about the wire capture holes in the posts, the answer would be yes. Not sure what size bit to use on that atty though. I drilled post holes on an Igo-L and used a 1/16" bit to do it and it was ok. Keep in mine that the posts on that atty are brass so they shouldn't take much to drill through them.
- Status
