RX200s Chip board

Status
Not open for further replies.

IMFire3605

Ultra Member
ECF Veteran
May 3, 2013
2,041
3,148
Blue Rapids, KS, US
I do not believe that Wismec/joyetech publically release spare control boards of their mods, however being the mod is the RX200 formfactor, the original RX200 came in 2 flavors, the Wismec board and the Evolv DNA200 board. Might need some internal modding to work but you can get the DNA200 maybe even a DNA250 board to fit into your mod. However the cost of the dna boards are probably as much as the lower cost RX200/RX200S in price, might be more beneficial to just buy a new one. But the price of the dna boards is due to quality, they are considered one of the Cadillac control boards out there with their own software to adjust things and upgrade firmware called Escribe.
 
  • Like
Reactions: JP Molony

mongo74

I'm your huckleberry.
ECF Veteran
Nov 15, 2016
2,117
6,652
51
Ωhmsville
Did you try firing it shortly after you fell in, or did you let it dry overnight first? More importantly, did you try a new set of batteries? It could be residue on the board if you let it dry for 24 hours before firing. There are no direct replacement boards available, so you'd be better off buying a new RX.

Since it's already not working properly, it's a little risky and not recommended if you're uncomfortable, you can try flushing the mod out with pure grain alcohol or isopropyl alcohol (remove batteries, dunk it in a bowl of it for a few seconds and shake it around and then remove..repeat again) and then let it dry for 24 hours near indirect heat. Then, outdoors in case something decides to no go NOPE, you can install the batteries and see if it works normally again...just make sure it's completely dry...wait 48 hours if you can. I fixed my Alien mod this way after juice leaked into it, drowning the board and causing it to not fire.
 
  • Like
Reactions: Continuity

BrotherBob

ECF Guru
ECF Veteran
Dec 24, 2014
14,136
12,456
Sunnyvale,CA,USA
Hello guys.
So two weeks ago i was pushed into the swimming pool with my rx200s in my pocket and so i fried the chip board.
Its as if the fire button is continuously pressed, constantly firing !
So my question is, WHERE CAN I PERCHASE A RX200S CHIP BOARD TO REPLACE MINE WITH ?
Thanks in advance.
Welcome and glad you joined.
Might like to read:
All About Sub-Ohm Vaping - The Perks and the Problems
What is Sub Ohm Vaping? Our Sub Ohm Vaping Guide & Tips
Battery safety
Care and Use of 510, eGo and Variable Voltage Batteries
ECF Sub-Ohm Advisory
 
Status
Not open for further replies.

Users who are viewing this thread