rx200s setup

[Bradley Last]

hi everyone
I've just bought the rx200s mod with the aspire tank with a 0.4 coil which says 40-60w just wondered what's the best settings to use it on as there is a few on the rx200s. any advice would be great thanks

 

[retired1]

Moved to Temperature Control

 

[louiesquared]

Which Aspire tank? Is it a TC coil or Kanthal?

 

[Bradley Last]

aspire Cleito tank

 

[Bradley Last]

think it may need updating aswell as it throws me back to VW when I try and change the settings and it's zapping my mouth a little

 

[KenD]

What material is the coil? It sounds like kanthal as it throws you into vw mode (you need a coil capable of temperature control for the other modes - stainless steel 316 for ss mode, titanium grade 1 for ti mode, ni200 for ni mode). If it's a non-tc coil, just set it to vw mode to a low wattage and increase until it performs satisfactory.

Sent from my M7_PLUS using Tapatalk

 

[Bradley Last]

thanks
it came with a spare coil
0.2 which says 55-70w

 

[KenD]

thanks
it came with a spare coil
0.2 which says 55-70w

The coil material is what's import. If it's not a tc-capable material (ni200, ti01, ss) it won't work in temp control mode. Ss can be used in both tc and vw. Start with low watts and increase until you're satisfied.

Sent from my M7_PLUS using Tapatalk

 

[louiesquared]

thanks
it came with a spare coil
0.2 which says 55-70w

Both coils that come with the Cleito are Kanthal Fused Claptons. They do not work in TC Mode. There is a 0.4 ohm SS316 coil available for TC.