Series box auto fires when battery's are in

[Animeevo]

I have a duel 18650 series box mod and it fires up when I insert both batteries (not touching the button) and doesn't stop till there out. How can I fix this??

 

[AstroTurf]

I have a duel 18650 series box mod and it fires up when I insert both batteries (not touching the button) and doesn't stop till there out. How can I fix this??

Send it back to the manufacturer for repair.

 

[bigrf85]

sounds like a faulty button or an atty that has a 510 pin that isnt protruding enough

 

[Hans Wermhat]

Probably a bad switch, but can't say for sure without seeing it. Could be a short in the wiring too.

 

[roxynoodle]

Is this mechanical, regulated or using a mosfet? If its mechanical you may just need to make an adjustment to the switch.

 

[suprtrkr]

Mosfet box? Might be a bad pulldown resistor (or pullup, however it's wired). Could be the mosfet failed on, but they usually go south off. In a mech, you have a welded-closed button.

 

[Animeevo]

The paint on the positive side of the batteries melted alittle

 

[Hans Wermhat]

You have a short, and it sounds like your batteries may have vented. That takes a LOT of heat.

 

[Hans Wermhat]

Wait...

The paint on the positive side of the batteries melted alittle

If it's series, the positives should be at opposite ends of the mod. If you put the positives at the same end, you just found your problem.

 

[Animeevo]

It is a series the left battery port is positive down and the right on up

 

[Hans Wermhat]

There are half a dozen things that could be wrong. I don't want to give you advice and tell you the wrong thing and have you end up on the news with half your face blown off. If you can't figure it out on your own, you should really take it to someone and let them fix it for you.