Thanks BackDoc. Well I was fiddling with the telescoping feature of the Z5 yesterday using the 18500 battery and looking at quarter inch gap it left between the upper and lower sections. It got me wondering about how much spring compression there was so for the heck of it I popped out the spring and screwed the base on. Was very suprised to see the display light just as it snugged up. Vaped with it like that till battery needed charging, was nice being shorter and without the bit of wobble. After charge reassembled and the display didn't come back on first time but after a couple tries it did. Is a very close fit.
Anyway I made a small spring from a piece of copper wire. Has less than an eighth inch of travel but worked fine to make a consistent connection. Tightened main tube to top and used bottom cap to firm connection. That got rid of wobble and at least allows bottom vent holes a bit of breathing room. Have not seen this discussed in back pages but I have not read every page in this thread. The pic shows first first spring I made, shape similar to the logo on plastic fire button. Have since made another that has an extra wind but not seeing much difference. Both snap into the groove in the bottom cap so they stay put once in place. Can also see in pic the gap between cap and tube roughly equal to thickness of the compressed copper spring.
View attachment 621325
Wow Kenno, a compact 18500Z, great thinking......I don't believe that modding a Z in this way has ever been discussed here....,.... PS: where did you find a black Z v5?..... I want one
Got my black Z5 here BackDoc with two 18500s. $25 total and free shipping.
Sigelei Zmax V5 Body
Didn't know there was a problem of pushing the circuit board out of place VapieDan. My sense is the solid seating with short spring will be less forgiving than the long spring for those prone to over-tightening. If not for remote chance of venting would be inclined to skip spring entirely on the compact 18500 configuration and just seat all the shoulders so it would be impossible to over snug. Will dig around archives and read that section. Thanks for pointing that out.
Just another observation, the end caps on V2 and V5 are interchangeable. The stainless V2 cap on black V5 didn't look too bad...
That has SS fire button and older style top ring and cap. Sweet! How long have you been using? Finish looks like it is holding up well. Is that a spacer above endcap? Looks kinda like lock ring on a mech mod.
Oh I've seen the fix in this thread. Seems straightforward enuf. Just can't imagine how to get the top off without marking up the top cap/beauty ring thingy.@Foggy Road sorry to hear that you put one of your beloved Z's out of service. I could not imagine how to take one of those apart to fix it.
I keep posts like yours in mind every time I swap batteries and reinstall the cap trying to be mindful that over tightening can break the mod.
Best of luck fixing it.
Oh I've seen the fix in this thread. Seems straightforward enuf. Just can't imagine how to get the top off without marking up the top cap/beauty ring thingy.
Take pics if ya' can. I always love the DIY stuff no matter how many times I see it.Thanks Dan! Looks good and I just might have one. But looking at that adapter gives me the idea that one of my old Evod bases might work just as well. Speshly ifn I screw in a coil, minus center pin and grommet.
Really weren't all that much to it. Found an old T3 base.Take pics if ya' can. I always love the DIY stuff no matter how many times I see it.
Sent from my LGLS992 using Tapatalk