I don't think it looks like a Provari either. It's more in line with an Zmax I think, But Phil Busardo says He thinks it does and he has some shots on his site.
It does do 20 watts, but lowest voltage is 3.3...unlike a Provari 2 which will go to 2.9volts.
It's the teardrops and tapered cap that makes it look like a ProVari. I wonder why they did that? Hmmm... I would go with a sigelei Zmax or Vamo over this thing.
I think even 15w is overkill. I've never gotten above 10w on my Vamo V3 without getting a burnt taste, and that's with all manner of delivery devices (except RBA/RDA). I don't see what practical advantage a 20w device could deliver.
I think even 15w is overkill. I've never gotten above 10w on my Vamo V3 without getting a burnt taste, and that's with all manner of delivery devices (except RBA/RDA). I don't see what practical advantage a 20w device could deliver.
Looks nice, better looking than the SID, IMHO. 20 watts max is nice too, albeit higher than I use. May make it dangerous for some new vapers. Probably uses the 'max' chip, so I am not a fan because of the low pulse width modulation frequency that it uses. <shrugs> time and the reviewers will tell. Thanks for sharing.
I can't find the ampacity for it either. Control of power by whole increments is annoying. 0.5 is as high as I'd want to increase at a time. Plus, if it is just pulse modulation.. what is the real point? I wouldn't get another RMS mod with out direct voltage as an option.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.