Squape reloaded junkies and kayfun junkies
- Thread starter 8tone8
- Start date
- th_trl_thread_readers 0
- Status
kaifuns are tried and tested.. good workhorse.. but a hassle to refill and surely a PITA to rewick if u still hv fluid inside. well the SquapeR, well... different beast altogether. easy to rewick, even with full tank, decks options, toolless airflow adjust.. well it ticks all the right box for sure!
Rewick is a breeze actually, even full on the Kayfun....
Stand the kayfun up on its tip in your juice bottle and unscrew the bottom plate. All the juice comes out the drip tip.....5 minutes tops even full after practice.
Stand the kayfun up on its tip in your juice bottle and unscrew the bottom plate. All the juice comes out the drip tip.....5 minutes tops even full after practice.
Had the kf lite plus v2,but still prefer the 3.1.
What I didn't like abt the v2 is the afc below.if you leave the afc screw on at times it will somehow at some point unscrew itself and either jam up your tank or mod or leave memories of lines.even with the afc nut removed,if it was used on certain mechs like sir lancelot where tanks sits really flush the afc will be pointless.not the forget the whistling mine made.filling on the other hand,sometimes top fill or bottom.no problemo.
The 3.1 on the other hand,not much changes with the v2.a nice touch with the leak well below,though adding extra work at times.the filling valve however I nvr ever used or tried,top fill all the way.I don't trust these clones and don't want to risk the bearing not getting in place and leaking its way out.however I did come across a 3.1 clone which I believe is from ehpro..the filling valve didn't have the bearing spring loaded mechanism,instead it uses the same screw like the afc which is slightly longer and wider.however imo I don't take risks with these clones.the design on a 3.1 is more sleek imo.kayfuns have nvr dissapointed me with their balance of vapour and flavour.ahhh waiting for the kayfun 4!!!!!
The squape however is a game changer.
-easy to build foolproof deck
-easy wicking
-adjustable 510
-3 sized decks
-great tank capacity
-afc control ring
-easy acess to coil without a mess
-easy fill method(with patience)
The squape really had me at a tight spot over the kayfuns.I had massive leaks on my squape before till I found out the inner tank isn't sealed nicely therefore losing vacuum.I had to remove the inner plastic tank and set it up again(it was stressful,quite like a surgery job too)just made sure the tank is sealed with the oversized white o rings tightly and wala....the champion hits.some clones come with those oversized o rings and been mistaken it has no use,believe me u will need it!
The decks however I prefer the W deck.great flavour esp vapour with short pulls @11 watts.removing the decks was another tough job tho.after much skin tearing I found out the easiet way to remove it without shedding skin.unscrew the bottom connector and use a metal rod or screwdriver to push the whole assembly up.careful not to use + screwdrivers to avoid damaging the 510 pin threads.I use a - screwdriver to push it up,nothing gets in the threads.
Overall the squape and kayfuns are still my favorite tanks of all time.I like the kayfun for chilling out and the squape for heavy blasting.
Now sitting back awaiting the taifun gt 2 with afc ring and kayfun 4 to surprise me
What I didn't like abt the v2 is the afc below.if you leave the afc screw on at times it will somehow at some point unscrew itself and either jam up your tank or mod or leave memories of lines.even with the afc nut removed,if it was used on certain mechs like sir lancelot where tanks sits really flush the afc will be pointless.not the forget the whistling mine made.filling on the other hand,sometimes top fill or bottom.no problemo.
The 3.1 on the other hand,not much changes with the v2.a nice touch with the leak well below,though adding extra work at times.the filling valve however I nvr ever used or tried,top fill all the way.I don't trust these clones and don't want to risk the bearing not getting in place and leaking its way out.however I did come across a 3.1 clone which I believe is from ehpro..the filling valve didn't have the bearing spring loaded mechanism,instead it uses the same screw like the afc which is slightly longer and wider.however imo I don't take risks with these clones.the design on a 3.1 is more sleek imo.kayfuns have nvr dissapointed me with their balance of vapour and flavour.ahhh waiting for the kayfun 4!!!!!
The squape however is a game changer.
-easy to build foolproof deck
-easy wicking
-adjustable 510
-3 sized decks
-great tank capacity
-afc control ring
-easy acess to coil without a mess
-easy fill method(with patience)
The squape really had me at a tight spot over the kayfuns.I had massive leaks on my squape before till I found out the inner tank isn't sealed nicely therefore losing vacuum.I had to remove the inner plastic tank and set it up again(it was stressful,quite like a surgery job too)just made sure the tank is sealed with the oversized white o rings tightly and wala....the champion hits.some clones come with those oversized o rings and been mistaken it has no use,believe me u will need it!
The decks however I prefer the W deck.great flavour esp vapour with short pulls @11 watts.removing the decks was another tough job tho.after much skin tearing I found out the easiet way to remove it without shedding skin.unscrew the bottom connector and use a metal rod or screwdriver to push the whole assembly up.careful not to use + screwdrivers to avoid damaging the 510 pin threads.I use a - screwdriver to push it up,nothing gets in the threads.
Overall the squape and kayfuns are still my favorite tanks of all time.I like the kayfun for chilling out and the squape for heavy blasting.
Now sitting back awaiting the taifun gt 2 with afc ring and kayfun 4 to surprise me
U got that right[emoji41] however my squape do get a little heaty at times
done with the orchird 2/3/4/5 myself.its a good rba for sure but its just not my thing.flavour gets off at times..vapour production is by far the best not to forget the airflows,gotta give em that.but the rapid juice drain and it gets gunky quickly on certain juices just not my thing[emoji28] I just kept the v2 in the line with a bell cap[emoji41] low juice capacity on the v2 works fine for me as I don't have to sacrifice juice to clear gunk.it finishes at just the right timing to rewick and such.I'm more to quality of flavour and vapour balance[emoji4] .... different ppl has different preffrences,I won't intervene[emoji28] [emoji41]
I vouch for kteto. You guys shd get the orchid v4. Freaking better than KF. You can use KF parts too, just need to get the orchid v4 atomizer base and chimney.
Orite, just got my hands on the UD AGA T5.so called also the kayfun competitor,its really WORTH it.the flavour,the vapour plus the afc ring.its like a kayfun with an afc.lemme get this guy running a few more times so I can really give a feedback anyone tried any of these china designed tanks?I can tell ya I'm impressed
anyone tried any of these china designed tanks?I can tell ya I'm impressed8stone8 - Ha..mine also dual coil and should be able to block the airhole for single coil, google for fogger thread, some user block one of the airhole, can't recall how they do it.
T5 is freaking good, my build 26g 9/10 loop on 3mm, crank up to 25w-30w and you will get a nice warm vape..no nic require..
Zizibar - I'm using my exiting KF deck and top cap and I suppose we got from the same supplier..ha
T5 is freaking good, my build 26g 9/10 loop on 3mm, crank up to 25w-30w and you will get a nice warm vape..no nic require..
Zizibar - I'm using my exiting KF deck and top cap and I suppose we got from the same supplier..ha
8tone8 - hi bro. I already replied your pm.
Hi everyone! May I know in your opinion. What is your favorite e juice?
Hi everyone! May I know in your opinion. What is your favorite e juice?
For me I'm more to paddle pop rainbow by vaping robot.its not too creamy nor too cool.its balanced8tone8 - hi bro. I already replied your pm.
Hi everyone! May I know in your opinion. What is your favorite e juice?
8stone8 - Ha..mine also dual coil and should be able to block the airhole for single coil, google for fogger thread, some user block one of the airhole, can't recall how they do it.
T5 is freaking good, my build 26g 9/10 loop on 3mm, crank up to 25w-30w and you will get a nice warm vape..no nic require..
Zizibar - I'm using my exiting KF deck and top cap and I suppose we got from the same supplier..ha
Word.the t5 rocks.it friggin puts the kayfun away for good.the flavour,the vapour esp!boom!can't wait to try some silica with this baby.gotta love these china designs,they sure are getting there.its like a kayfun+taifun only with AFC!classy with the glass tank,really solid device.got mine gold with ss,really a charm.the packaging is neato too.if only they came with the drip tip
But there are a few "hassle" with these guys.
Filling port:the top filling port can really really be a annoying as the screw is not the standard + .its really tiny too,might even drop in the chimney if you're clumsy.the filling port to me is definitely a no go.but its kinda fixed as I'm filling the from the bottom Taifun style using a syringe or a needle bottled filler.
The base afc ring.its so damn spinny loose during unscrewing for a refill and I'm still figuring out how to remove/dissamble the base to remove the ring for cleaning.any ideas?
Apart from the cons,its still managable.the filling is fixed by bottom fill,get yourself a few of those needle tip bottles.the base assembly still a mystery,hope anyone can help me out here.the cons are just minor cons that doesn't get in the way of its performance.its a GREAT TANK.PERIOD.definitely recommended to new users upgrading from vivi nova or ego(get the fck out of that zone!seriously!)or kayfun lovers looking for the sole competitor.
- Status
Similar threads
