SS mesh 70/30 juice oxidizing

[Trü2ThãVãpõr]

any tips on size mesh?
size for 70/30(400or300)
center channel?
fill hole open?
how long to oxidize (flat&rolled)
like a minute, or heat cool down, repeat
until black?
saw a YouTube vid, where a guy holds
his rolled wick in a propane flame for
2min31secs!
that overkill?
reason I ask, I cannot get my juice to taste
as it does with silica wick on a genesis!
have a 150$ cobra. So I would love to eexperience the
majic people talk about!
have a aga T+ for my 2nd eVic control head.
yet to set up due to this!
thanks

 

[Kanj.nguyen]

500 mesh.

No center hole.

Oxidize by burning till it glows, let cool, repeat 3 times.

Remember to use higher wattahe than would be on silica, since you are losing a lot of heat into the mesh.

 

[Trü2ThãVãpõr]

Thank you, darn it got tons of 300&400.
No 500, will get some! Ok I oxidized right!
You sure 500?
What about fill hole?
Closed or open?
So my 1.7 ohm coil, I should vape At what volt?
On my eVic?
It is working with a channel and 400 mesh!
Flavor not all there!
Also how is the ribbon wire?
Thank you

 

[Kanj.nguyen]

I have heard ribbon wire doesnt make that much of a difference.

Keep fill hole open. I do.

EVic has variable wattage, just keep dialing around until you find a good spot. Remember, if wattage is too low, you wont get newrly enough flavor.

Check out the rebuildable atomizer section in the forum. You sound quite unsure about what youre doing, and lack of information will lead to tons of headache with an AGA. There are still many issues to iron out.

 

[Trü2ThãVãpõr]

I am actually using the cobra™ official from
Phiniac. Ti, not ss.
That's y I'm frustrated!
150$ lol
Have a aga... Yet to set up due to this.
So it is possible to get pure flavor like silica
Taste with genesis?

 

[Trü2ThãVãpõr]

Yes troubles, gone though 10 wick tries.
Used like 100ml in process!
That sux ...!!
Scuse me

 

[Kanj.nguyen]

Phoenix or AGA, same deal, any rba can be infuriating when you dont know whay youre doing.

Silica does not provide the purest flavor, in fact, it is inferior to both steel mesh and cotton.

 

[Trü2ThãVãpõr]

I'm vaping good flavor with 400ss, at 4.1-4.3 v
Thank you Nguyen !!
The wait is over, 2 weeks.. Finally vaping clouds of flavor!

 

[eHuman]

400 mesh works fine but get 500 when you can.
Read my blog: 2 part AGA-T set up. Properly set up, an RBA needs no break in time to get outstanding full flavor from the first pull.

 

[Trü2ThãVãpõr]

Thank u ehuman!!