4 wrap folded 28g kanthal. Fully oxidized
90 mm 400 mesh, rolled tight onto a 1/20 Allen key. Use screwdriver in the fold, held in your winding hand, to hold even tension on the wire. Slow, tight winds, holding tension with the screwdriver pulling on the fold of the wire. Attach coil/wick to the pos post. Tighten down carefully, make sure wires are running parallel. Leave it alone now.
Snug up the coil really good to the wick. It will expand some, during the pulsing-out step. Your winding hand still has the wire fold/screwdriver, keeping tension. After your wraps are evened out, capture neg lead on the deck of the atty. Leave Allen key inside of wick while you do this. Leave wick raised up some also. After you are done with your coil, scooch wick down into proper position. Make coil adjustments.
On the Did, ohmed out to 0.7Ω; On the Aga Hydra ( smaller wick-hole, less mesh, 0.6Ω).
Pulsed it out really well. juice burns, vape. Really really, nice
Sent from my iPhone using Tapatalk
Snug up the coil really good to the wick. It will expand some, during the pulsing-out step. Your winding hand still has the wire fold/screwdriver, keeping tension. After your wraps are evened out, capture neg lead on the deck of the atty. Leave Allen key inside of wick while you do this. Leave wick raised up some also. After you are done with your coil, scooch wick down into proper position. Make coil adjustments.
On the Did, ohmed out to 0.7Ω; On the Aga Hydra ( smaller wick-hole, less mesh, 0.6Ω).
Pulsed it out really well. juice burns, vape. Really really, nice
Sent from my iPhone using Tapatalk
Last edited:
