Subtank Mini

[arcanaheartx]

Hi,

Is any1 using subtank mini here and notice i had small leaks ?

 

[V4pe]

Mine was from the air flow control, and got into the ring. Due to flooding and gurgling from the rba.
Try not to blow in on it or Suck unnecessarily hard. Mine is fine now. Remember smaller hole equals to tighter draw and also create a stronger vaccum in the tank, and makes it gurgle and flood.

 

[Damaurian]

All 510s leak...it's just a part of vaping. Its more of a codensation issue for me. On the battery pin, just your vapor condensing onto the cool metal. Although, I'm not sure if you're having leaks from your airflow ports or what...but I also had that issue. The seal on your tank must be real tight Ive noticed, in order for it to not leak through the air ports. If you tighten it too much and crack it, thankfully a spair has been provided and plenty of places to buy replacements.

 

[wsjh]

figured out that most of the leaks is from the air flow control. maybe set it to the smallest airhole to minimize leaks. As for the spitting issues, i havent found a fix yet.

 

[Elipse2Be]

I also faced the issue with my Atlantis 2. As i DIY my own coil and stuff using the original atomizer( Not really sure if it's called that as still having trouble knowing all the names of the parts), I think maybe is not enough blockage of the holes from the cotton and slowly it seeps through and leak in and exit through my air hole. I also experience the spitting issues. I think is due to the watt too high then its too hot and the juice start boiling and splatter everywhere. My atlantis 2 will be covered with juice at the drip tip and the base part where is screwed into the mod( dk wad isit called). Correct me if I'm wrong hahas.

 

[DragonSG]

Mine has none of such issues, so its likely a faulty RBA base, or incorrect wicking.

Only my TF GT II leaks sometimes (known issues, same with most RTAs), due to its large air tube and I adjust to too small airholes in AFC for MTL hits, problem disappear when I open up the AFC.

 

[chia]

Mine has none of such issues, so its likely a faulty RBA base, or incorrect wicking.

Only my TF GT II leaks sometimes (known issues, same with most RTAs), due to its large air tube and I adjust to too small airholes in AFC for MTL hits, problem disappear when I open up the AFC.

hey thanx ur post reminded me there is a small pc of plastic/silicon in the spares bag.. shoved it in the the airhole to close it up a bit.. and the draw seems better now some combo of air hole I still get a bit of gurgling, but not all and the gurgling seems a bit getter now.
have you tried the plastic/silicon yet?