super 6 help

[wood_510]

I wanted to use my super 6 at 6v and my cr2 batteries seem to be too long and when threading the top cap back on the atomizer fires constantly. the cr2 batteries aren't protected. Is there an extension for this or am I missing something.

Thanks, Eric

 

[jwquantrell]

Hey Wood,

I don't have the Super 6, but i believe that there are washers on the button assembly that you need to take off to use it at 6v. Maybe someone can clarify ?

Regards
Jim

 

[wood_510]

ahh man thanks... didn't even notice those were there....

 

[KonaNeil]

Hey Wood,

I don't have the Super 6, but i believe that there are washers on the button assembly that you need to take off to use it at 6v. Maybe someone can clarify ?

Regards
Jim

I do use an S6.

JW's correct. When you unscrew the adapter, on the inside you'll see several brass washers captured by a flat head screw. Just remove one or possible two washers. Don't forget to re-install them when you go back to a single 14500 battery.

 

[wood_510]

works like a charm guys and gals... thanks so much for the help... I love the s6... a little bit of a pain to change voltages but it's still amazing once you pick the voltage you want..

 

[BrockJ]

I replaced the washers with an 8-32 brass screw and nut. It makes it really easy to just unscrew the screw a little and run the nut down.
Not so much fiddlin...

 

[wood_510]

I will go to the hardware store and pick one up tomorrow... Thanks BrockJ

 

[JRWReich]

I just swap out the springs... works great.