I used to like the low ohm rowdy builds but now i've mellowed into the single coil 0.5/6 and even higher if we are talking about an 18350 battery.
- Status
I forgot to mention i've managed to get myself 3 BBB boro slides with the engraved logos so i'm really happy...
Very stylish. Quite beautiful. I'm trying to read the third B - is it Billet Box ?I forgot to mention i've managed to get myself 3 BBB boro slides with the engraved logos so i'm really happy...
It's Bay....the whole logo refers to a famous fb group where all the BB greats hang out. Billet Box Bay. I've been after these for ages...they don't come up very often
I've never understood these builds, looks like a wide 28ga fused coil over a tiny 2mm center air hole.
Hi Charlie
I've never understood these builds, looks like a wide 28ga fused coil over a tiny 2mm center air hole.
I bet this coil would produce amazing flavour and if it's Ni 80 it could be at or around 0.5 ohms so great for single battery mods...
Even if the air stream is racing out of the 2mm hole and hitting the base of the coil it will soon be diffused throughout the chamber/coil....especially in a mini rba. YMMV
Hope you're well?
I'll have to try something like that in Russian Fusion RTA and see how it works. I put a similar coil in the Insider when I first got it and it didn't fare so well. I was trying to run the coil with the power required for such a coil and the airflow just wasn't there.Hi Charlie
I bet this coil would produce amazing flavour and if it's Ni 80 it could be at or around 0.5 ohms so great for single battery mods...
Even if the air stream is racing out of the 2mm hole and hitting the base of the coil it will soon be diffused throughout the chamber/coil....especially in a mini RBA. YMMV
Hope you're well?
But like you say YMMV.
Always!
The shop is going to bring in some RY4, the 30ml sample bottle arrived today and I already have it half gone.
I do love me some RY4.
I don't have much experience with RY4, but one of my favorite ejuices is Basix Series - Creamy RY4 Butterscotch Reserve. Funny, I don't taste the RY4, butterscotch, or caramel in it. In fact, I can't pinpoint any particular flavor in there at all. Except I love the combination of whatever it is. And it really does well with mesh coils and it bursts into many different wonderful flavors.I do love me some RY4.
Thanks Bill. I ordered me some
I'm a sucker for a good RY4. The one I like lately is Charlie Noble's pistachio RY4. I found the clone recipe (it also contains butterscotch) and ordered all the flavors to make my own. Bit expensive the way I run through it.
Last edited:
That positive pin has no hole in the center. I'm to understand though that the 510 bridge for it adds some restriction.
I've never understood these builds, looks like a wide 28ga fused coil over a tiny 2mm center air hole.
That makes much more sense now and might not be half bad.
Yes.. I saw these. The clear ones are very popular with the OG as they show off the internals such as the trvp panels and the friendly flipper.
Now you're talking. Airlfow looks generous. Can't wait to find out
Still don't have a Bantam (on the way!) but no way I'm using a rebuildable. It'll be more for Nord coils, since I use one but I don't like it to be unregulated.
I don't have any and still I love those. Also you can print something and stick it in the back, the poor man solution to new doors... Better yet, the broke solution to new doors.
Eeeeeeewh.... That's horrible
- Status
