Hi. I am used to using the condom method for my Boge 2.0 cartos. I do have access to a lot of syringes and needles though b/c I work as an EMT. I am wondering if anyone can post a good video guide so that I can see how to fill with a syringe. I assume that 18g with a 3-5ml syringe would be best. Thank you.
Syringe filling 510 carto
- Thread starter ilgreatluigi
- Start date
- th_trl_thread_readers 0
- Status
It's pretty easy to do you just stick the needle between the wall and the pollyfill and slowly squeeze in the juice..you might take a break occasionally to allow it to soak in or you could fill it some on one side then the other. Anyways below is a link to a YouTube search 
Syringe filling 510 carto - YouTube
Syringe filling 510 carto - YouTube
Hello and welcome to ECF. I am a fellow Paramedic. I use a 3cc syringe with an 18g. On a fresh carto fill syringe with about 1 1/2 cc of juice and place the needle off to the side a the filler flush with the side of the carto (so beteen the filling and the wall), push the needle all the way down to the bottom and slowly inject the juice until it looks slushy on top, then just blow any fluid out of the center like you do with the condom method. On a refill you will prob. only need a 1/2 cc or a little more. Good luck.
The same way as I was saying pretty much..but you don't have to go all the way to the bottom..I would say at least half way though. The YouTube link I posted before isn't that great..some people fill it from the bottom but that would be much like the condom method..doing it from the side probably would be best with a syringe. If you practice it enough you won't have excess juice to blow out most of the time.
http://www.e-cigarette-forum.com/forum/tutorials/212616-syringe-method-refilling-cartomizers.html Found it on these forums in the Tips and Tricks board
Crispy Critter,I think we were posting at the same time.
Could be..it happens to me all the time lol...
Thank you for your post. The video that critter posted also suggests that the needle should go to the bottom for ample filling.
http://www.e-cigarette-forum.com/forum/tutorials/212616-syringe-method-refilling-cartomizers.html Found it on these forums in the Tips and Tricks board
This video was most helpful! Thank you or your post.
Does anyone find that the syringe method works better then the condom method? I feel like sometimes I can't saturate the poly-fill correctly every-time. Even if I go slowly, it will spurt and just settle until I draw back the condom a bit. This seems to trigger the fluid to retreat instead of settling into the poly-fill. Thus, even after the condom fill method and a couple of top-offs, I still get a burnt taste sometimes.
This is a copy and paste I wrote for someone else on how to fill the Ressurectors. Do the same thing for the Boges, they just hold less juice. The Ressurectors hold alittle over 2ml of juice and the Boges hold 1ml-1.2ml. Follow these directions exactly and you should have no problems. I don't know what kind of needle your using, but I recommend using a syringe with an inch and a half long needle. That way it will go all the way to the bottom of the Ressurectors.
Here ya go:
How to fill a cartomizer with a syringe:
"All you have to do is take the dropper part of the bottle off your juice and fill your syringe with 2ml for a new carto. Take the rubber tip off the carto and carefully insert the needle down the side pushing against the metal. DO NOT go thru the filler because it will move it and you could potentially break a connection and your carto. Slide the needle down the side and go all the way to the bottom. Then slowly start dispensing some juice. Dont dispense it all bc then it won't be evenly distributed. Put alittle in, then take it out and insert the needle in a different spot. I normally do it in 3 spots (in a triangle) I found it distributes the best, but you could just do it in 2, on opposite sides. Make sure the needle is at the bOttom bc then you will not have to wait at all for it to settle. Disperse slowly and you will begin to see the toP of the filler become slushy. It is full then, don't put more. If its a new carto is will def hold 2ml, if your refilling it won't take a lot so pay attention and once it gets alittle slushy stop. While your filling hold a napkin or something under the carto bc if you do it too fast a few drops will come out the battery end. If that happens its only bc you did it too fast and the poly fill didn't absorb quick enough.( that happens to me bc I am impatient and fill it in about 10 sec, so I just hold a paper towel or napkin underneath.) wipe up the drops and put the rubber cap back on the carto. Then put the carto between your hands and rub back and forth spinning the carto quickly. This will insure the liquid is evenly distributed in case you put too much on one side from the syringe.
Now you have a perfectly filled ressurector that is ready to be used right away!"
It's really easy to do and I think tou pick it up very quickly. Just watch the top of the filler carefully and fill slowly and you will see the juice rise to the top of the filler. Once the top becomes slushy, it's full.
Here ya go:
How to fill a cartomizer with a syringe:
"All you have to do is take the dropper part of the bottle off your juice and fill your syringe with 2ml for a new carto. Take the rubber tip off the carto and carefully insert the needle down the side pushing against the metal. DO NOT go thru the filler because it will move it and you could potentially break a connection and your carto. Slide the needle down the side and go all the way to the bottom. Then slowly start dispensing some juice. Dont dispense it all bc then it won't be evenly distributed. Put alittle in, then take it out and insert the needle in a different spot. I normally do it in 3 spots (in a triangle) I found it distributes the best, but you could just do it in 2, on opposite sides. Make sure the needle is at the bOttom bc then you will not have to wait at all for it to settle. Disperse slowly and you will begin to see the toP of the filler become slushy. It is full then, don't put more. If its a new carto is will def hold 2ml, if your refilling it won't take a lot so pay attention and once it gets alittle slushy stop. While your filling hold a napkin or something under the carto bc if you do it too fast a few drops will come out the battery end. If that happens its only bc you did it too fast and the poly fill didn't absorb quick enough.( that happens to me bc I am impatient and fill it in about 10 sec, so I just hold a paper towel or napkin underneath.) wipe up the drops and put the rubber cap back on the carto. Then put the carto between your hands and rub back and forth spinning the carto quickly. This will insure the liquid is evenly distributed in case you put too much on one side from the syringe.
Now you have a perfectly filled ressurector that is ready to be used right away!"
It's really easy to do and I think tou pick it up very quickly. Just watch the top of the filler carefully and fill slowly and you will see the juice rise to the top of the filler. Once the top becomes slushy, it's full.
- Status
Similar threads
- Locked
