TC Mode

[NT3N531]

I have a g-priv using the Big Baby Beast. I want to use the temp control because everyone says it save juice and battery. I don't know anything about TCR. I don't know what temp is a good to start off and what would be too high too low? I looked on the net and didn't really get any info. I don't want to get into it until I get some info(Don't want to do anything wrong since it only came with 2 coils and haven't bought any more yet. any advice thanks

 

[Cheallaigh]

in order to use TC... you need TC wire... build the RBA with either Ni/Ti/SS coils, then you can use TC best.

 

[puffon]

Lots of info in this forum:
Temperature Control
420f is a good temp to start at. Adjust from there.

 

[dobroeutro]

I have a G-Priv using the Big Baby Beast. I want to use the temp control because everyone says it save juice and battery. I don't know anything about TCR. I don't know what temp is a good to start off and what would be too high too low? I looked on the net and didn't really get any info. I don't want to get into it until I get some info(Don't want to do anything wrong since it only came with 2 coils and haven't bought any more yet. any advice thanks

Don't think they offer TC pre-made coils for the Big Baby Beast. Looks like you'll need to use the RBA deck & Ni/Ti/SS wire to build your coils to use TC...