Temp control, SS316L, 2 mods, 1 build, different results.

[untar]

Just mark this as solved.

Not so fast
Are you using the exact same batteries in both mods? Does anything change when you swap the batteries?

 

[Brandonwarrington]

Same cell for comparison. I switched the cell and the rda. Did that from the start.. The Vandy Vape mod just doesn't produce the watts it claims it should in TC. I give up with the VV.. garbage

 

[Brandonwarrington]

It pushes 30w at ramp up when I tell it to do more.. 60, 70, 80, 90.. don't matter.. I visually and vape twice as slow as the other mod..

 

[Brandonwarrington]

It's built well though.. g10 panels are solid and beautiful. =[

 

[Brandonwarrington]

I have 2 hg2s, a 25r, and an efest 20700. All perform the same

 

[TrollDragon]

NVM...

 

[Brandonwarrington]

@TrollDragon

I put in power mode at 60w.. Great vape, delivers the 60w giving me a 60w vape. I wish temp control would work at 60w..

 

[Brandonwarrington]

Thank you everyone. I tried to thumbs you all for your help. =]

 

[TrollDragon]

@TrollDragon

I put in power mode at 60w.. Great vape, delivers the 60w giving me a 60w vape. I wish temp control would work at 60w..

Well it's a shame that TC mode doesn't work as it should on all devices. The only TC mode I use these days is on DNA devices or anything that will take the Arctic Fox firmware (Joyetech/Wismec/Eleaf).

Good luck with it.

 

[Mr. Relentless]

Crank it to 450f and see if you get a good vape. If so then run it dry and see if your cotton burns. Readouts dont always tell the truth.