The Kanger subtank mini - I like it but..

Status
Not open for further replies.

Papillon61

Ultra Member
ECF Veteran
Mar 22, 2015
1,491
3,528
Sunshine Isle
,,it's going to get some getting used to.I think the problem is that the chimney is relatively short... not much space between the coil head and bottom of the mouthpiece. The result is a much warmer - i would say hotter - vape than I am used too. I have a Kanger Geni Mini and even on that small tank there's a longer distance between coil and mouth piece. On the 1.2 ohm coil I have to keep the istick at 10 watts, 11 at most or else it's too warm for me. Sub-ohming will be a learning curve!
 

gpjoe

Ultra Member
ECF Veteran
Verified Member
Oct 30, 2013
2,595
4,950
Up North
,,it's going to get some getting used to.I think the problem is that the chimney is relatively short... not much space between the coil head and bottom of the mouthpiece. The result is a much warmer - i would say hotter - vape than I am used too. I have a Kanger Geni Mini and even on that small tank there's a longer distance between coil and mouth piece. On the 1.2 ohm coil I have to keep the istick at 10 watts, 11 at most or else it's too warm for me. Sub-ohming will be a learning curve!

No rule that says you must vape at high wattage. ;)

I vape my Subtank Minis at less than 10 watts with .5-ohm OCCs on my iStick30s. Works for me and my battery lasts longer.

And technically you aren't sub-ohming if you are using a 1.2-ohm coil. :)
 

Papillon61

Ultra Member
ECF Veteran
Mar 22, 2015
1,491
3,528
Sunshine Isle
Try getting a new tip..

I was thinking of that. I saw some pretty looking long tips, very much like a cigarette holder, and thought that might work better for me As for the airflow, yes, it felt strange at first but now I already feel the flavour is much better with a wider airflow.
 

gpjoe

Ultra Member
ECF Veteran
Verified Member
Oct 30, 2013
2,595
4,950
Up North
Oh, I gotcha.

I see a lot of folks saying their vape is too warm or they get dry or burnt hits and I always think "turn it down". Might be that folks get too caught up in the wattage numbers. Best way to find what you like is to sart low and increase. If it's too much - stop and back it down a notch. That's your number. I know that Kanger gives a range of recommended wattage depending on the coil resistance, which is fine, but it's not etched in stone.

You'll find your own sweet spot I'm sure. :)
 
Status
Not open for further replies.

Users who are viewing this thread