Partspro, I have the same istick as you, the 20w. I like my coils at 1.2-1.5 ohms generally. Thanks for your help! I was told awhile back to get a Taifun GT clone but I can't find the one the person told me to get. It's by EHPro.
The Official Nicoticket " Get the most from your juice thread."
- Thread starter distortoblotto
- Start date
- th_trl_thread_readers 0
- Status
Partspro, I have the same istick as you, the 20w. I like my coils at 1.2-1.5 ohms generally. Thanks for your help! I was told awhile back to get a Taifun GT clone but I can't find the one the person told me to get. It's by EHPro.
Lynn, the Orchid may be too advanced at this point for you. It's fitted for dual coils, you have to know how to contain inherent leakage issues. I would start with a Lemo or Lemo Drop before I went to an Orchid. They are MUCH easier to build on than an Orchid. PM me if you are looking for a lemo
Just to throw my .02 in here. I have a full size Lemo and 2 Lemo Drops. I would buy another Drop before the full size. The Drop seems to be more consistent for some reason. The full size is just more finicky after refills.
My juice get's fouled up more in the full size 'cause I vape gunky stuff. Mah nod goes to the Drop as well...
Lynn, the Aqua is very easy to get a single coil build on, and it comes with a little screw for the second air hole. The one challenge I've seen is stuffing the juice channels for the uncoiled side with wick to prevent flooding, but folks seem to figure it out pretty easily. I'll put up a link to a good thread you can read through to see if you think you can tackle it. Have you built other RDA/RTA's?
Here's a good thread for you to look over the Aqua clones and people's builds:
http://www.e-cigarette-forum.com/forum/rta/627322-aquav2-clone-thread.html
http://www.e-cigarette-forum.com/forum/rta/627322-aquav2-clone-thread.html
Yes. I have an RM2 on a Reo and a Magma that a wonderful fellow NTer gifted me with. So a little bit! Lol
I don't have any experience with the Aqua, so I am of little or no help on that one girl! Sorry
I don't have any experience with the Aqua, so I am of little or no help on that one girl! Sorry
No problem sweet pea!
No problem sweet pea!
Lynn,
If you get one, I will help you with it. However, if you aren't using Rayon for wicking , you might consider it. It seems to be more forgiving than Cotten. I can help you with the Lemo as well if you decide to go that route.
Does anyone have both the Lemo Drop and an istick? Wondering how well it would fit on a 30w istick???
Works fine on a 20, but hangs over the top edge a little. They fixed that with the 30 by flaring out the upper chrome cap. I am waiting for the 50s to come out myself.
You'll be just fine, I have both of those, and the Aqua builds just as easily. Difference is wicking, the tails of the wick go into the juice channels.
- Status
Similar threads
