The REO Lounge - Part IV

Status
Not open for further replies.

nerak

ECF Guru
ECF Veteran
Verified Member
Feb 12, 2011
25,335
60,415
Fairfield Township, OH, USA
www.facebook.com
Good morning!

Still trying to figure out how to get my backwards magnet out of the door...:confused:

Robert usually suggest the hot soldering iron, and then smacking the door, magnet side down on the edge of a table. Sometimes just the smacking it will pop it loose.

Some have found a stronger magnet will pull it out too. But the heat softens the glue and works to assist.
 

MikeMills

Super Member
ECF Veteran
Verified Member
Mar 8, 2014
485
729
SoCal OC

Robert usually suggest the hot soldering iron, and then smacking the door, magnet side down on the edge of a table. Sometimes just the smacking it will pop it loose.

Some have found a stronger magnet will pull it out too. But the heat softens the glue and works to assist.

I tried that and heating it with a little gas torch, also boiled it in water.

Good thing it's a raw one...:)

Oh well, I have plenty of time to tinker with it, it has to succumb to my persistence eventually.

Update: It's all good now.
 
Last edited:

Sterno

ECF Guru
ECF Veteran
Verified Member
May 12, 2010
24,681
38,062
59
Oklahoma City
www.reosmods.com
A great morning to all of REOville. Is good to be back and vaping my Woodvile again. I will cut back on the chain vaping and not go through 10-15mls day. I couldn't have asked for a better birthday yesterday.

hey there Gill good to see ya :)

happy birthday buddy :bday:
 
Last edited:

unsure

ECF Guru
ECF Veteran
Verified Member
Feb 6, 2010
19,529
41,435
75
Silicon Valley, California
hey there Gill good to see ya :)

happy birthday buddy :bday:

howdy-smiley.gif
Scott and thank you my friend.
Great news Gil. Did you get accustomed to your new/old digs?

Oh yeah....like riding a bike (if I could still ride one) :) Heading to the doc's office for some x-rays. You all enjoy this fine day.
 
Status
Not open for further replies.

Users who are viewing this thread