The Russian 91%

[Paradicio]

Hi all,

I'm looking to get a Black Russian 91% and am wondering where I should order from? I normally don't post for store recommendations, but it's quite a bit of money and I want to make sure I'm ordering from a reputable shop....

Thanks in advance for the help!

 

[DougFNJ]

I got mine from Jersey Devil vape shop in Waretown, NJ. They have been straight up with my equipment.

 

[Stewbacca]

I have ordered several R91's from evcigarettes. Good service and fast shipping, I usually have received my orders within 4 days.

 

[Paradicio]

Thank you!

 

[Jdbaker82]

I really want the black Russian too its so sekzy

Sent from my SCH-I545 using Xparent Skyblue Tapatalk 2

 

[Bsweat75]

I've got a clone and would drop the dough on a genuine if I knew it wouldn't leak. Let us know what you think and good luck

 

[Paradicio]

I've got a clone and would drop the dough on a genuine if I knew it wouldn't leak. Let us know what you think and good luck

Will post a review as soon as I get it and have gotten to vape on it a bit!

 

[JohnnyK717]

I've got a clone and would drop the dough on a genuine if I knew it wouldn't leak. Let us know what you think and good luck

I've never had a problem with my Russian leaking. I've had problems with my Kayfun plenty of times though

 

[Mada]

Vapordna, fair price, fast shipping

 

[Jugband]

I've never had a problem with my Russian leaking. I've had problems with my Kayfun plenty of times though

I'm just the opposite. I have an original Kayfun and a Russian 91%. I've never had a day of trouble with my Kayfun, but my Russian has not worked well since day one. I finally gave up on it went it started leaking juice. But I know people have had much better experiences then I did. In case your interested I bought my Russian from Smokin Crow. Wasn't there fault, I just must have got a defective one. I never tried to return it, I always thought I could fix it. By the time I gave up on it I was certain I was past my warranty.

 

[rurwin]

My R91% leaked a little around the fill screw, until I put a tiny O-ring on it and now there's no more leaks.

On my last two tankfuls I found it had a problem with high-VG liquids, but a dash of water solved that too.

It's still my favourite tank, but the new Fogger v4 might give it a run for its money.

 

[Jake67]

I purchased my Russian from Vapor life. No leaking. My only challenge is getting more than 1 1/2 tanks before it starts tasting burnt. I was vaping 90/ 10 VG/PG and thought that could be the problem. changed to 70/ 30 same problem. Reduced the amount of cotton same problem. Changed to larger diameter same problem. Increased the OHMs same problem.
Vaping on a Provari 2.0 OHMs 3.6 volts . Unless chain vaping may be the issue I am wondering if it may be the unit.

 

[Coldrake]

I've got a clone and would drop the dough on a genuine if I knew it wouldn't leak. Let us know what you think and good luck

A "genuine" clone?

 

[Paradicio]

Got it today, my wife picked it up from VaporDNA for me. Took it to my local shop and got a 1.2ohm build. They also talked me into getting a DNA 30 clone....

Only got to vape on it a bit, but man the difference in flavor was noticeable right off the bat! Simply amazing! More to come after I've done a few fills and changed the wick, etc.... But here's the setup.....

 

[rurwin]

I purchased my Russian from Vapor life. No leaking. My only challenge is getting more than 1 1/2 tanks before it starts tasting burnt. I was vaping 90/ 10 VG/PG and thought that could be the problem. changed to 70/ 30 same problem. Reduced the amount of cotton same problem. Changed to larger diameter same problem. Increased the OHMs same problem.
Vaping on a Provari 2.0 OHMs 3.6 volts . Unless chain vaping may be the issue I am wondering if it may be the unit.

It does need time to wick, especially with thicker liquid. Try adding water until you don't have to wait for the air bubble to move. I find it suffers less from chain vaping than the Protank II does, but a primer puff now and then cures it.

 

[Paradicio]

So after a bit more time vaping on my new Russian, I've got a question for those experienced with RBA's....

I've been vaping 12mg on my Aerotank, but vaping the same juice on my Russian gives me a crazy strong throat hit. To the point that it burns a bit. I'm wondering if the coil is to hot or if I should tone down to 6mg?

Appreciate the help!

 

[DougFNJ]

I have found the nicotine hits much harder on a rebuildable than my bottom coils. It worked for me though as it got me to finally lower my dosage.


Sent from my iPad using Tapatalk

 

[NealBJr]

My R91% leaked a little around the fill screw, until I put a tiny O-ring on it and now there's no more leaks.

On my last two tankfuls I found it had a problem with high-VG liquids, but a dash of water solved that too.

It's still my favourite tank, but the new Fogger v4 might give it a run for its money.

...fogger V4... just got this a month ago... I don't think I'll need another dual coil tank... it's pretty much perfect IMO. Don't vape it while driving though, you'll need to see the road.

 

[slappy3139]

So after a bit more time vaping on my new Russian, I've got a question for those experienced with RBA's....

I've been vaping 12mg on my Aerotank, but vaping the same juice on my Russian gives me a crazy strong throat hit. To the point that it burns a bit. I'm wondering if the coil is to hot or if I should tone down to 6mg?

Appreciate the help!

Yeah I had to cut my nic levels when transitioning to rbas.

Sent from my SM-G900V using Tapatalk

 

[Carlbren21]

It is a great device!