Threads stuck on my new RDA...Help!!

Status
Not open for further replies.

tehgyu

Senior Member
Oct 12, 2013
72
144
ON, Canada
The top cap is a 3 part assembly. The top part threads to the bottom part right above the airflow control ring. The whole top cap goes over the deck and is secured by 2 O-rings. Twist off the top of the top cap and push down from the center post while holding the bottom of the top cap should get the deck out. Before putting the deck back in, put a little e-liquid on the O-rings. It will make it easier to remove when you need to rebuild. Hope that helps.
 

Vapeaholic

Ultra Member
ECF Veteran
Verified Member
Jan 25, 2014
1,529
8,754
NE Texas
The top cap is a 3 part assembly. The top part threads to the bottom part right above the airflow control ring. The whole top cap goes over the deck and is secured by 2 O-rings. Twist off the top of the top cap and push down from the center post while holding the bottom of the top cap should get the deck out. Before putting the deck back in, put a little e-liquid on the O-rings. It will make it easier to remove when you need to rebuild. Hope that helps.
Neither the tank halves or the deck will turn.
It's spending the night in the freezer, and will try again in the morning. I had to walk away from it for a bit, before I ended up with a little Helios sized hole in the wall.
Thanks for the ideas.
 
Status
Not open for further replies.

Users who are viewing this thread