tight draw on ssggts/odysseus and gurgley leaks =(

[Mac_206]

Ok so I searched around and asked a buddy about the tight draw I'm getting on this combo are there any tricks or suggestions to this. My air control is wide open, could it be the ody center pin is down too far? Also I'm getting some slight leaks. I did fill to the top of liquid control, so does tightening down push the liquid through like when you push the top down on a carto tank? Any help would be greatly appreciated my gg fam. Sorry it upside down, trying to show air control is wide open, also my liquid control is just slightly cracked with a short wick. I think I just figured out the problem to my question. But if I use Krinkles method with nextel w/o modding ceramic cup the leaks should be minimal yea? smh pls help

Marco

 

[fright88]

Just curious from our conversation last night I thought you meant low vapor production. Are you having tight draw also?

 

[Mac_206]

Just curious from our conversation last night I thought you meant low vapor production. Are you having tight draw also?

Oh sorry buddy but yes my low vapor production and draw were tight. It seems to be okay after about 20-30mins of vaping but the draw seems tight still, especially when I fill a fresh tank it seems to flood.. Maybe because im filling it up too high. Approx above the liquid control when it's screwed all the way shut.

 

[fright88]

I fill mine up all the way never had a tight draw though. For a tight draw I would take it off he GGTS and suck see if the draw is tight. If it is and it isn't flooded maybe there is some vasoline in the post?

 

[Poppa D]

Remove the Ody, using a paper clip check the air tube for blockage. Also check the 4 air holes on the GGTS control tank, sometimes they get plugged.

 

[MrKrinkle]

what those 2 guys up there said.... thats what you do... you do it now...

 

[Mac_206]

thanks my friends! Krinkle you got incoming pm

 

[imeothanasis]

leakage is coming from center pole because liquid goes there Mac. A new trick to avoid this is to put the negative wire around the ceramic housing but not in a full circle, (about 3/4 of a circle) so the big ring will sit well on this wire

 

[Mac_206]

Thank you Imeo my friend!! Will redo this tomorrow, I think the center pole is too far down as well...


SSGGTS#141+Odysseus

 

[Mac_206]

all fixed, thanks again friends!

 

[fright88]

Glad you got it working.