Tugboat v2 clone wont fire on Hana Mod v3 dna 30

Status
Not open for further replies.

yovengo

Senior Member
ECF Veteran
Dec 27, 2014
155
30
Houston,TX,USA
We need more info on what you have in your atty to help with you getting your DNA30 & rda working correctly. What kind of coil set up did you build on your tugboat? How many ohms does it read on your mod/ ohm reader if you have one?
Just a single coil 11 wraps on a 2.4mm screwdriver, most likely a 1.2 ohm resistance.
 

yovengo

Senior Member
ECF Veteran
Dec 27, 2014
155
30
Houston,TX,USA
Probably the atty isn't connecting to the mod due to the non adjustable 510.

You could try adding a circuit board spacer from Madvapes. Or maybe a 510 to 510 adaptor would work.

Or Hana will replace the 510 with a spring loaded one for $30. You could also do it yourself for about $5 if you're handy.

Yeah thats what i was thinking, i might go with the circuit board spacer. Thanks for your help!
 

yovengo

Senior Member
ECF Veteran
Dec 27, 2014
155
30
Houston,TX,USA
You're welcome. Hope it resolves the problem. Might as well grab a few as it could be easy to lose, and just in case you need to double them up for this or other attys.

Thanks again!! Works amazing and only needed 1 but i ordered 3 so oh well lol
 

Attachments

  • Snapchat--3731760234968828124.jpg
    Snapchat--3731760234968828124.jpg
    447.1 KB · Views: 10
  • Like
Reactions: roxynoodle
Status
Not open for further replies.

Users who are viewing this thread