Two Vision Spinners 1300mah not working

[Tess Clark]

I mainly use my MVP 2, but I also picked up three Vision Spinner 1300mah batteries from VividSmoke. After only a short time using them, two of the three aren't working. Fully charged, I've swapped everything around to rule out a clearomizer problem, everything looks clean and fine, the LED comes on like normal, but no joy. I'm guessing that it's something simple and silly that I just haven't thought of.

 

[DetraMental]

Have you tried prying the center pin of the battery up a bit? Use a small jewelers flat head or a toothpick and pry the pin up and around.

 

[Tess Clark]

I hadn't yet, but will as soon as I get my hands on them, thanks so much for the suggestion!

 

[Cullin Kin]

Have you tried clicking the fire button five times fast?

ETA: Have to rule out the simple stuff first.

 

[SupplyDaddy]

Most likely it is the center pin . Screwing your devices on too tightly will compress the o-ring on the battery.

 

[Susan~S]

If it is a center pin problem make sure that if you use something conductive (metal) to pry up on the center pin that you do NOT hit the fire button while you are working on the battery. Or better yet, turn off the battery.

Center Pin Issue - Fixing a non firing eGo battery

 

[Tess Clark]

It was the center pin, thank you so much.

 

[DaveP]

Cranking them down to hard on the charger or screwing the atomizer in too far will definitely push the center contact too far. No charge, no vape when that happens.

 

[classwife]

Glad you got things fixed

Moved to eGo Type Models from Simple Solutions
Simple Solutions is to assist the beginning vaper in getting started

 

[Kent C]

Prying up the center pin does work but sometimes only temporarily, and you have to continually do it. Here's a permanent solution:

circuit board spacer from madvapes - outside is insulated to stop shorts, inside connects...

Circuit Board Spacer