UFS help!

[Hawaiiboay]

Hey there and thank you for looking. I'm having trouble with my UFS. New to the system...
After reading and watching a number of YouTube videos I feel like I shouldn't be having this problem but my atomizer floods.... Even with the juice control and air valve completely closed. What could be the cause of this. I have tried this with fuzions nice melons 6ml if that means anything. Please help!

 

[imeothanasis]

Hi Hawai

1. Screw well the small cap
2. If you dont have an o-ring around the threads of the upper body, please put one 16x1
3. Screw well the atomizer first on UFS connector by having the UFS liquid control totally open.
4. Check your o-ring between caps. I have send an extra o-ring when I made the 510 atomizer extension that was thinner than the usual o-ring, so you maybe have the smaller o-ring instead of the original even if you dont use the 510 atomizer extension

 

[Hawaiiboay]

Hi Hawai

1. Screw well the small cap
2. If you dont have an o-ring around the threads of the upper body, please put one 16x1
3. Screw well the atomizer first on UFS connector by having the UFS liquid control totally open.
4. Check your o-ring between caps. I have send an extra o-ring when I made the 510 atomizer extension that was thinner than the usual o-ring, so you maybe have the smaller o-ring instead of the original even if you dont use the 510 atomizer extension

Hey there Imeo... Here to save the day again. Haha
The small cap is screwed on as tight as I can and then backed off. As for the o ring on the upper body, if I'm on the same page you're on, I already have one. When I screw on the atomizer I have the liquid control fully open, then I close the liquid control tightly onto the atomizer. And as for the extention, it didn't come with one (bought this second hand) but I have an extended drip tip that fits on the atomizer and snuggly outside the top cap (about an inch above ). The guy I bought this from said this was what he was using and it worked for him.... Did Not work for me though. I did buy a 510 extension and just waiting for it to come in. Maybe I'll just wait for that to arrive and try again. I also bought new o rings so I'm hoping that'll solve the problem. Was just hoping it was something numb I was doing ... backwards. Ooh... And by the way.. All threads and o rings are Vasolined well

 

[imeothanasis]

Maybe while you close the liquid control, the mouthpiece opens and liquid escapes inside atomizer.

When you have liquid control totally closed and you refill, you have gurgling and after some time you have burn taste? If that happens, that means that UFS seals well but your atomizer is not suitable with UFS, it gets flooded very easy

 

[Hawaiiboay]

Maybe while you close the liquid control, the mouthpiece opens and liquid escapes inside atomizer.

When you have liquid control totally closed and you refill, you have gurgling and after some time you have burn taste? If that happens, that means that UFS seals well but your atomizer is not suitable with UFS, it gets flooded very easy

Okay, that could be the issue. I ordered so. E that was recommended to me from a few guys on here but I figure Instead of being patient, i went down to our plaza and picked an atomizer up from volcano e cigs (we are so extremely limited with vaping supplies on this island). But I guess I'll just have to wait for the Cisco atomizer to come in. I hate the waiting game.... Haha

 

[imeothanasis]

keep us informed hawai

 

[dspin]

Hawaii, just remember ALL atomizers fit differently in the UFS. Also you can have 6 Cisco attys and perhaps one or two wont vape right and/or will flood.

Some attys will vape excellent - some will flood no matter what you do. Such is the nature of them.