can you tell me which piece you mean imeo? tx for the advice. it is something i haven't tried yet so i will give it a go... just not sure which piece you're referring to
UFS problems
- Thread starter wigglr
- Start date
- th_trl_thread_readers 0
- Status
I sent this to a friend about osmething I noticed today:
Hear this...I put the atty and the juice control ring together (leaving off the window and everything above it)
I closed the air control ring... and I could still get a light draw.....?
I slid down the center post (so it no longer touches the atty) and while doing that the draw stopped (which I think should be the case)
So in all... when the center post was slid tot he top and touching the atty, it was airy-er than I think it should be
Hear this...I put the atty and the juice control ring together (leaving off the window and everything above it)
I closed the air control ring... and I could still get a light draw.....?
I slid down the center post (so it no longer touches the atty) and while doing that the draw stopped (which I think should be the case)
So in all... when the center post was slid tot he top and touching the atty, it was airy-er than I think it should be
Imeo i'm still having problems
If you still have problems then your atomizer isnt feeded. Its not a good atomizer for UFS buddy. Maybe you have to try something like Bruce's DC atomizers that all people say they are exellent inside UFS.
if you close CR then you will still can take a draw wigl.Atomizer is breathing from its side holes.
if you close CR then you will still can take a draw wigl.Atomizer is breathing from its side holes.
Even if I closed off the juice control ring?
my only advice is to take it completely apart, remove all o-rings, clean off any lube, run everything under hot water, use a toothpick to make sure air holes are clear, lightly lube o-rings and reinstall, lightly lube threads and reassemble all parts.
Yes wig. You cant stop air without an o-ring. But you can stop liquid and especially our liquids that are thicker than water
Keep the top piece loose, it will Prevent air pressure buildup while you screw down the cap after filling
I've tried keeping the top loose and I tried the dual coil atomizer. No luck. Back to AVS
hahaha i know that feeling. i almost threw it against the wall. luckily i realized it was a 400 dollar device
i still get dry hits with the air open the SLIGHTEST bit and the juice control fully open
thanks dspin -- i just keep trying and trying so hopefully i can get everything working optimally soon
There is no reason to send it back Dspin. The only reason that UFS cant get feeded (exept of the atomizer inside it), is the upper channel around its connector. If there are no threads in the first 1,5mm, the UFS is ok.
I like to opened the 2nd cap above the clear window a little bit until I see air bubbles. Then I know the atomizer has juice and I can vape.
- Status
