My v3 is making a clicking kind of grinding sound when I press it.I have cleaned everything and changed the screw,applied noalox to all of the threading and center pin and I'm still getting this grind? Thanks in advance.
V3 switch ?
- Thread starter luvinitall
- Start date
- th_trl_thread_readers 0
- Status
Hmmmm ...
Never heard of this happening before. Almost sounds like something isn't lined up properly.
Try loosening the screw just a tad (don't wrench it down) -- Allow is to be a bit more free and see if that *loosens* it up.
Otherwise, you can also try pulling the hexagonal post out and rotating it.
Give those couple things a shot luvin
Never heard of this happening before. Almost sounds like something isn't lined up properly.
Try loosening the screw just a tad (don't wrench it down) -- Allow is to be a bit more free and see if that *loosens* it up.
Otherwise, you can also try pulling the hexagonal post out and rotating it.
Give those couple things a shot luvin
Thanks Cash, I loosened the screw and rotated the post, but I'm still getting that sound ? not as bad though?
hmmm .... that does seem odd. Almost like the plastic is sticking to a thread maybe?
I would say (when you have a few minutes that is) -- Take it back apart. Rotate that post, and I'm pretty sure you should find a slot that is smooth as butter. If not, you are always free to shoot it in to us, and I can figure out
keep me posted
I would say (when you have a few minutes that is) -- Take it back apart. Rotate that post, and I'm pretty sure you should find a slot that is smooth as butter. If not, you are always free to shoot it in to us, and I can figure out
keep me posted
I fixed it ...for some reason the spring was making the noise?? I flipped it and yeah! NO NOISE!
VERY nice! LOL....
Thinking about it now ... The end coils will slip over the 2nd to last coil. Perhaps that was the issue?
Either way, happy to see you got it resolved luvin
have a great week!- Status
