Vapor Flask clone - Low Voltage err msg

[ToolmanTexas]

My Vapor Flask clone keeps getting a "Low Voltage" err msg after firing for a few seconds.

I have 2 red eFest 2000 mah batteries in her.

SKU # 2055201 on fasttech (no longer avail).

Any input is appreciated!

 

[ToolmanTexas]

Bump......

 

[Rcajun]

Have you tried tightening down the top? Was getting weak battery on my authentic and that fixed the issue.

Don't know anything about the batteries, maybe they cannot support the draw.

 

[Nathan Summers]

I have a Vapor Flask v2 clone....Love it!....I ordered it from FastTech some time ago....From what I found, It will not run a coil build lower than 3.5 ohms....Hope that helps

I also have just came across a problem with mine....apparently it only uses one of the two batteries in the devise....I have checked this a few times to make sure....It only drains one battery while not draining the other at all....When I got the VF, I put two charged up batteries in it and left them in, only charging it through the cable at night....I never thought to check it before....I felt that the batteries were not lasting as long as I thought they should, so I changed them out and came across this problem....Do you have this problem or have you came across it?

 

[ToolmanTexas]

I changed my batteries to Sony VTC4s and have not had the err msg any longer.

i'm not sure about the draining 1 batt... my charge goes a long time but I'll double check.

 

[roxynoodle]

I was suspicious it was the batterys. Glad you got it solved.