Vapor Flask/wismec issues

[csAdams]

I have 2 vapor flask lites. For the most part I'm very happy with them, however I am haveing an issue with my newer one. When my battery's are 3/4 full down to drained I'm getting the low battery message. This only
seems to happen when I unlock the device. It's a pain because I click 5 times to unlock but it doesn't register because of the message. After the message displayes the screen returns to normal but, is still locked and will not fire until an additional 5 clicks are applied. I'm running the current firmware, and have tried several different battery's.
Anyone else experiencing this?

 

[gofishtx]

Just curious if this happened after you installed the latest firmware. If so you can try re-installing the older version or even re-installing the newer version and see if that helps.

 

[csAdams]

I tried reinstalling the firmware, same problem. It seem its misreading the voltage when woken up or unlocked. The more I try to figure it out the more I think it's a bad chip.

 

[gofishtx]

I tried reinstalling the firmware, same problem. It seem its misreading the voltage when woken up or unlocked. The more I try to figure it out the more I think it's a bad chip.

So this has the Wismec Chipset not the dna. It probably is a bad chip. You can check out the Vendors warranty or Wismec. Did you recently install the Update and then started having problems?

 

[csAdams]

I installed the update before I used it. I have another that works fine, I guess this ones going back. Also seems it could be dangerous if it's misreading the voltage.